Skip to contentSkip to conversation

cfg80211: Add wiphy flag to trigger STA disconnect after hardware restart

PATCH In review Youghandhar Chintala 1 participant 1 message Dec 15, 2020

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/3 cfg80211: Add wiphy flag to trigger STA disconnect after hardware restart

Many wifi drivers (e.g. ath10k using qualcomm wifi chipsets) support silent target hardware restart/recovery. Out of these drivers which support target hw restart, certain chipsets have the wifi mac sequence number addition for transmitted frames done by the firmware. For such chipsets, a silent target hardware restart breaks the continuity of the wifi mac sequence number, since the wifi mac sequence number restarts from 0 after the restart, which in-turn leads to the peer access point dropping all the frames from device until it receives the frame with the mac sequence which was expected by the AP.

Add a wiphy flag for the driver to indicate that it needs a trigger for STA disconnect after hardware restart.

Tested on ath10k using WCN3990, QCA6174.

---
 include/net/cfg80211.h | 4 ++++
 1 file changed, 4 insertions(+)
include/net/cfg80211.h +4 -0
index ab249ca..7fba6f6 100644
@@ -4311,6 +4311,9 @@ struct cfg80211_ops {
  * @WIPHY_FLAG_HAS_STATIC_WEP: The device supports static WEP key installation
  *	before connection.
  * @WIPHY_FLAG_SUPPORTS_EXT_KEK_KCK: The device supports bigger kek and kck keys
+ * @WIPHY_FLAG_STA_DISCONNECT_ON_HW_RESTART: The device needs a trigger to
+ *	disconnect STA after target hardware restart. This flag should be
+ *	exposed by drivers which support target recovery.
  */
 enum wiphy_flags {
 	WIPHY_FLAG_SUPPORTS_EXT_KEK_KCK		= BIT(0),
@@ -4337,6 +4340,7 @@ enum wiphy_flags {
 	WIPHY_FLAG_SUPPORTS_5_10_MHZ		= BIT(22),
 	WIPHY_FLAG_HAS_CHANNEL_SWITCH		= BIT(23),
 	WIPHY_FLAG_HAS_STATIC_WEP		= BIT(24),
+	WIPHY_FLAG_STA_DISCONNECT_ON_HW_RESTART	= BIT(25),
 };
 
 /**
Signature · 1 line
2.7.4