net/igc: remove MTU setting limitation
PATCH 1/1 net/igc: remove MTU setting limitation
From: Dapeng Yu <[email protected]>
Currently, if requested MTU is bigger than mbuf size and scattered receive is not enabled, setting MTU to that value fails.
This patch allows setting this special MTU when device is stopped, because scattered_rx will be re-configured during next port start and driver may enable scattered receive according new MTU value.
After this patch, driver may select different receive function automatically after MTU set, according MTU values selected.
Fixes a5aeb2b9e225 ("net/igc: support Rx and Tx")
Signed-off-by Dapeng Yu <[email protected]>
--- drivers/net/igc/igc_ethdev.c | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-)
drivers/net/igc/igc_ethdev.c +6 -4
@@ -1590,12 +1590,14 @@ eth_igc_mtu_set(struct rte_eth_dev *dev, uint16_t mtu)return -EINVAL ;/* -* refuse mtu that requires the support of scattered packets when -* this feature has not been enabled before. +* If device is started, refuse mtu that requires the support of +* scattered packets when this feature has not been enabled before. */ -if (!dev->data->scattered_rx && - frame_size > dev->data->min_rx_buf_size -RTE_PKTMBUF_HEADROOM ) +if (dev->data->dev_started && !dev->data->scattered_rx && + frame_size > dev->data->min_rx_buf_size -RTE_PKTMBUF_HEADROOM ) { +PMD_INIT_LOG (ERR ,"Stop port first." );return -EINVAL ; + } rctl =IGC_READ_REG (hw,IGC_RCTL );
Signature · 1 line
2.27.0