Skip to contentSkip to conversation

spi: Enable tracing of the SPI setup CS selection

PATCH Applied Andy Shevchenko 2 participants 2 messages May 26, 2021 – May 28, 2021

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 spi: Enable tracing of the SPI setup CS selection

It is helpful to see what state of CS signal was during one or another SPI operation. All the same for SPI setup.

Enable tracing of the SPI setup and CS selection.

---
 drivers/spi/spi.c          |  4 +++
 include/trace/events/spi.h | 57 ++++++++++++++++++++++++++++++++++++++
 2 files changed, 61 insertions(+)
drivers/spi/spi.c +4 -0
index 57120dea3273..ff719c1d93f5 100644
@@ -804,6 +804,8 @@ static void spi_set_cs(struct spi_device *spi, bool enable, bool force)
 	    (spi->controller->last_cs_mode_high == (spi->mode & SPI_CS_HIGH)))
 		return;
 
+	trace_spi_set_cs(spi, activate);
+
 	spi->controller->last_cs_enable = enable;
 	spi->controller->last_cs_mode_high = spi->mode & SPI_CS_HIGH;
 
@@ -3457,6 +3459,8 @@ int spi_setup(struct spi_device *spi)
 		spi_set_thread_rt(spi->controller);
 	}
 
+	trace_spi_setup(spi, status);
+
 	dev_dbg(&spi->dev, "setup mode %lu, %s%s%s%s%u bits/w, %u Hz max --> %d\n",
 			spi->mode & SPI_MODE_X_MASK,
 			(spi->mode & SPI_CS_HIGH) ? "cs_high, " : "",
include/trace/events/spi.h +57 -0

63 lines not on this page · raw message

Signature · 1 line
2.30.2
maintainer Applied
#1 lore raw

From: Mark Brown,,, <[email protected]>

Quoted 4 lines · Andy Shevchenko

It is helpful to see what state of CS signal was during one or another SPI operation. All the same for SPI setup.

Enable tracing of the SPI setup and CS selection.

Applied, thanks!

[1/1] spi: Enable tracing of the SPI setup CS selection

      commit: 5cb4e1f33e5eeadbce3814282e010d4dd31816af

Best regards,

Signature · 1 line
Mark Brown,,, <[email protected]>