ARM: dts: rainier: Add 'factory-reset-toggle' as GPIOF6

From: Isaac Kurth <[email protected]>

The state of this GPIO determines whether a factory reset has been requested. If a physical switch is used, it can be high or low. During boot, the software checks and records the state of this switch. If it is different than the previous recorded state, then the read-write portions of memory are reformatted.

Signed-off-by Isaac Kurth <[email protected]>

---
arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts | 2 +-

1 file changed, 1 insertion(+), 1 deletion(-)

arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts +1 -1

index 728855c5cb90..81be3a563e6a 100644
@@ -231,7 +231,7 @@ &gpio0 {
 	/*C0-C7*/	"","","","","","","","",
 	/*D0-D7*/	"","","","","","","","",
 	/*E0-E7*/	"","","","","","","","",
-	/*F0-F7*/	"","","","","","","","",
+	/*F0-F7*/	"","","","","","","factory-reset-toggle","",
 	/*G0-G7*/	"","","","","","","","",
 	/*H0-H7*/	"","bmc-ingraham0","rear-enc-id0","rear-enc-fault0","","","","",
 	/*I0-I7*/	"","","","","","","","",

Signature · 1 line

2.25.1