ath11k: enable IEEE80211_VHT_EXT_NSS_BW_CAPABLE if NSS ratio enabled

When NSS ratio enabled reported by firmware, SUPPORTS_VHT_EXT_NSS_BW is set in ath11k, meanwhile IEEE80211_VHT_EXT_NSS_BW_CAPABLE also need to be set, otherwise it is invalid because spec in IEEE Std 802.11™‐2020 as below.

Table 9-273-Supported VHT-MCS and NSS Set subfields, it has subfield VHT Extended NSS BW Capable, its definition is:
Indicates whether the STA is capable of interpreting the Extended NSS BW Support subfield of the VHT Capabilities Information field.

dmesg have a message without this patch:

[ 3143.177810] [5204] mac80211:ieee80211_register_hw:1258: ieee80211 phy0: copying sband (band 1) due to VHT EXT NSS BW flag

It means mac80211 will set IEEE80211_VHT_EXT_NSS_BW_CAPABLE if ath11k not set it in ieee80211_register_hw(). So it is better to set it in ath11k.

Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1

---
v2: change commit log
1. "IEEE Std 802.11™-2016" -> "IEEE Std 802.11™‐2020"
2. "Table 9-251" -> "Table 9-273"

 drivers/net/wireless/ath/ath11k/mac.c | 4 ++++
 1 file changed, 4 insertions(+)

index c73b2de11ae3..4c59cea34174 100644
@@ -4123,6 +4123,10 @@ ath11k_create_vht_cap(struct ath11k *ar, u32 rate_cap_tx_chainmask,
 	vht_cap.vht_supported = 1;
 	vht_cap.cap = ar->pdev->cap.vht_cap;
 
+	if (ar->pdev->cap.nss_ratio_enabled)
+		vht_cap.vht_mcs.tx_highest |=
+			cpu_to_le16(IEEE80211_VHT_EXT_NSS_BW_CAPABLE);
+
 	ath11k_set_vht_txbf_cap(ar, &vht_cap.cap);
 
 	rxmcs_map = 0;

2.31.1

Patch applied to ath-next branch of ath.git, thanks.

78406044bdd0 ath11k: enable IEEE80211_VHT_EXT_NSS_BW_CAPABLE if NSS ratio enabled

https://patchwork.kernel.org/project/linux-wireless/patch/[email protected]/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches