Skip to contentSkip to conversation

hwmon: (lm90) Add support for TI TMP461

PATCH New Guenter Roeck 1 participant 2 messages Oct 19, 2021

Subsystems (3)
lore
Share & tools
lore

Guenter Roeck

author maintainer
#0 lore raw

PATCH 1/2 hwmon: (lm90) Add support for TI TMP461

TMP461 is almost identical to TMP451 and was actually detected as TMP451 with the existing lm90 driver if its I2C address is 0x4c. Add support for it to the lm90 driver. At the same time, improve the chip detection function to at least try to distinguish between TMP451 and TMP461.

As a side efect, this fixes commit 24333ac26d01 ("hwmon: (tmp401) use smb word operations instead of 2 smb byte operations"). TMP461 does not support word operations on temperature registers, which causes bad temperature readings with the tmp401 driver. The lm90 driver does not perform word operations on temperature registers and thus does not have this problem.

Fixes 24333ac26d01 ("hwmon: (tmp401) use smb word operations instead of 2 smb byte operations")
Cc David T. Wilson <[email protected]>
Cc Andrew F. Davis <[email protected]>
---
 Documentation/hwmon/lm90.rst | 10 +++++
 drivers/hwmon/Kconfig        |  2 +-
 drivers/hwmon/lm90.c         | 75 ++++++++++++++++++++++++------------
 3 files changed, 61 insertions(+), 26 deletions(-)
Documentation/hwmon/lm90.rst +10 -0
index 3da8c6e06a36..05391fb4042d 100644
@@ -265,6 +265,16 @@ Supported chips:
 
 	       https://www.ti.com/litv/pdf/sbos686
 
+  * Texas Instruments TMP461
+
+    Prefix: 'tmp461'
+
+    Addresses scanned: I2C 0x48 through 0x4F
+
+    Datasheet: Publicly available at TI website
+
+	       https://www.ti.com/lit/gpn/tmp461
+
 Author: Jean Delvare <[email protected]>
 
 
drivers/hwmon/Kconfig +1 -1
index c4578e8f34bb..ccdaeafed0bb 100644
@@ -1317,7 +1317,7 @@ config SENSORS_LM90
 	  Maxim MAX6646, MAX6647, MAX6648, MAX6649, MAX6654, MAX6657, MAX6658,
 	  MAX6659, MAX6680, MAX6681, MAX6692, MAX6695, MAX6696,
 	  ON Semiconductor NCT1008, Winbond/Nuvoton W83L771W/G/AWG/ASG,
-	  Philips SA56004, GMT G781, and Texas Instruments TMP451
+	  Philips SA56004, GMT G781, Texas Instruments TMP451 and TMP461
 	  sensor chips.
 
 	  This driver can also be built as a module. If so, the module
drivers/hwmon/lm90.c +50 -25

175 lines not on this page · raw message

Signature · 1 line
2.33.0
author maintainer
#1 lore raw

PATCH 2/2 hwmon: (tmp401) Drop support for TMP461

TMP461 is almost identical to TMP451, which is already supported by the LM90 driver. At the same time, unlike other sensors from the TMP401 compatible series, it only supports 8-bit temperature read operations. Supporting this chip in the tmp401 driver adds unnecessary complexity. Remove its support from this driver and support the chip with the lm90 driver instead.

Fixes 24333ac26d01 ("hwmon: (tmp401) use smb word operations instead of 2 smb byte operations")
Cc David T. Wilson <[email protected]>
Cc Andrew F. Davis <[email protected]>
---
 Documentation/hwmon/tmp401.rst | 15 +--------------
 drivers/hwmon/Kconfig          |  2 +-
 drivers/hwmon/tmp401.c         | 25 ++-----------------------
 3 files changed, 4 insertions(+), 38 deletions(-)
Documentation/hwmon/tmp401.rst +1 -14
index 14bf1fbf4493..3aacf3d3bdf3 100644
@@ -43,12 +43,6 @@ Supported chips:
 
     Datasheet: http://focus.ti.com/docs/prod/folders/print/tmp435.html
 
-  * Texas Instruments TMP461
-
-    Prefix: 'tmp461'
-
-    Datasheet: https://www.ti.com/product/tmp461
-
 
 
 Authors:
@@ -60,7 +54,7 @@ Description
 -----------
 
 This driver implements support for Texas Instruments TMP401, TMP411,
-TMP431, TMP432, TMP435, and TMP461 chips. These chips implement one or two
+TMP431, TMP432, and TMP435 chips. These chips implement one or two
 remote and one local temperature sensors. Temperature is measured in degrees
 Celsius. Resolution of the remote sensor is 0.0625 degree. Local
 sensor resolution can be set to 0.5, 0.25, 0.125 or 0.0625 degree (not
@@ -84,10 +78,3 @@ some additional features.
 
 TMP432 is compatible with TMP401 and TMP431. It supports two external
 temperature sensors.
-
-TMP461 is compatible with TMP401. It supports offset correction
-that is applied to the remote sensor.
-
-* Sensor offset values are temperature values
-
-  Exported via sysfs attribute tempX_offset
drivers/hwmon/Kconfig +1 -1
index ccdaeafed0bb..feff41444f05 100644
@@ -1930,7 +1930,7 @@ config SENSORS_TMP401
 	depends on I2C
 	help
 	  If you say yes here you get support for Texas Instruments TMP401,
-	  TMP411, TMP431, TMP432, TMP435, and TMP461 temperature sensor chips.
+	  TMP411, TMP431, TMP432, and TMP435 temperature sensor chips.
 
 	  This driver can also be built as a module. If so, the module
 	  will be called tmp401.
drivers/hwmon/tmp401.c +2 -23
index 9dc210b55e69..cd72755ec8f7 100644
@@ -34,7 +34,7 @@
 static const unsigned short normal_i2c[] = { 0x48, 0x49, 0x4a, 0x4c, 0x4d,
 	0x4e, 0x4f, I2C_CLIENT_END };
 
-enum chips { tmp401, tmp411, tmp431, tmp432, tmp435, tmp461 };
+enum chips { tmp401, tmp411, tmp431, tmp432, tmp435 };
 
 /*
  * The TMP401 registers, note some registers have different addresses for
@@ -56,7 +56,6 @@ static const u8 TMP401_TEMP_MSB_READ[7][2] = {
 	{ 0x20, 0x19 },	/* therm (crit) limit */
 	{ 0x30, 0x34 },	/* lowest */
 	{ 0x32, 0x36 },	/* highest */
-	{ 0, 0x11 },	/* offset */
 };
 
 static const u8 TMP401_TEMP_MSB_WRITE[7][2] = {
@@ -66,7 +65,6 @@ static const u8 TMP401_TEMP_MSB_WRITE[7][2] = {
 	{ 0x20, 0x19 },	/* therm (crit) limit */
 	{ 0x30, 0x34 },	/* lowest */
 	{ 0x32, 0x36 },	/* highest */
-	{ 0, 0x11 },	/* offset */
 };
 
 static const u8 TMP432_TEMP_MSB_READ[4][3] = {
@@ -123,7 +121,6 @@ static const struct i2c_device_id tmp401_id[] = {
 	{ "tmp431", tmp431 },
 	{ "tmp432", tmp432 },
 	{ "tmp435", tmp435 },
-	{ "tmp461", tmp461 },
 	{ }
 };
 MODULE_DEVICE_TABLE(i2c, tmp401_id);
@@ -570,21 +567,6 @@ static const struct attribute_group tmp432_group = {
 	.attrs = tmp432_attributes,
 };
 
-/*
- * Additional features of the TMP461 chip.
- * The TMP461 temperature offset for the remote channel.
- */
-static SENSOR_DEVICE_ATTR_2_RW(temp2_offset, temp, 6, 1);
-
-static struct attribute *tmp461_attributes[] = {
-	&sensor_dev_attr_temp2_offset.dev_attr.attr,
-	NULL
-};
-
-static const struct attribute_group tmp461_group = {
-	.attrs = tmp461_attributes,
-};
-
 /*
  * Begin non sysfs callback code (aka Real code)
  */
@@ -686,7 +668,7 @@ static int tmp401_detect(struct i2c_client *client,
 static int tmp401_probe(struct i2c_client *client)
 {
 	static const char * const names[] = {
-		"TMP401", "TMP411", "TMP431", "TMP432", "TMP435", "TMP461"
+		"TMP401", "TMP411", "TMP431", "TMP432", "TMP435"
 	};
 	struct device *dev = &client->dev;
 	struct device *hwmon_dev;
@@ -717,9 +699,6 @@ static int tmp401_probe(struct i2c_client *client)
 	if (data->kind == tmp432)
 		data->groups[groups++] = &tmp432_group;
 
-	if (data->kind == tmp461)
-		data->groups[groups++] = &tmp461_group;
-
 	hwmon_dev = devm_hwmon_device_register_with_groups(dev, client->name,
 							   data, data->groups);
 	if (IS_ERR(hwmon_dev))
Signature · 1 line
2.33.0