arm: kirkwood: Pogoplug V4 : Use Marvell network PHY driver
PATCH RESEND 1/1 arm: kirkwood: Pogoplug V4 : Use Marvell network PHY driver
The Pogoplug V4 board has the network chip Marvell 88E1116R. So to properly configure the network, enable CONFIG_PHY_MARVELL to activate the compatible driver M88E1118R.
- This patch depends on the series:
https://patchwork.ozlabs.org/project/uboot/patch/[email protected]/
Signed-off-by Tony Dinh <[email protected]>
---
configs/pogo_v4_defconfig | 1 + 1 file changed, 1 insertion(+)
configs/pogo_v4_defconfig +1 -0
@@ -62,6 +62,7 @@ CONFIG_KIRKWOOD_GPIO=y CONFIG_MVEBU_MMC=y CONFIG_MTD=y CONFIG_MTD_RAW_NAND=y +CONFIG_PHY_MARVELL=y CONFIG_DM_ETH=y CONFIG_MVGBE=y CONFIG_MII=y
Signature · 1 line
2.30.2