Skip to contentSkip to conversation

serial: 8250_pericom: Revert "Re-enable higher baud rates"

PATCH New Andy Shevchenko 1 participant 1 message Feb 3, 2022 TTY layer and serial drivers

lore
Share & tools
lore

Andy Shevchenko

author
#0 lore raw

PATCH 1/1 serial: 8250_pericom: Revert "Re-enable higher baud rates"

UPF_MAGIC_MULTIPLIER is userspace available bit and can be changed at any time. There is no sense to rely on it to be always present.

This reverts commit b4ccaf5aa2d795ee7f47a6eeb209f3de981e1929.

Note, that code was not reliably worked before, hence it implies no functional change.

Signed-off-by Andy Shevchenko <[email protected]>
---
 drivers/tty/serial/8250/8250_pericom.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/tty/serial/8250/8250_pericom.c +1 -1
index 025b055363c3..95ff10f25d58 100644
@@ -117,7 +117,7 @@ static int pericom8250_probe(struct pci_dev *pdev, const struct pci_device_id *i
 	uart.port.private_data = pericom;
 	uart.port.iotype = UPIO_PORT;
 	uart.port.uartclk = 921600 * 16;
-	uart.port.flags = UPF_SKIP_TEST | UPF_BOOT_AUTOCONF | UPF_SHARE_IRQ | UPF_MAGIC_MULTIPLIER;
+	uart.port.flags = UPF_SKIP_TEST | UPF_BOOT_AUTOCONF | UPF_SHARE_IRQ;
 	uart.port.set_divisor = pericom_do_set_divisor;
 	for (i = 0; i < nr && i < maxnr; i++) {
 		unsigned int offset = (i == 3 && nr == 4) ? 0x38 : i * 0x8;
Signature · 1 line
2.34.1