ARM: optimize some variable accesses
PATCH 1/2 ARM: assembler: simplify ldr_this_cpu for !SMP builds
In reply to Ard BiesheuvelWhen CONFIG_SMP is not defined, the CPU offset is always zero, and so we can simplify the sequence to load a per-CPU variable.
--- arch/arm/include/asm/assembler.h | 14 ++++++++++---- 1 file changed, 10 insertions(+), 4 deletions(-)
arch/arm/include/asm/assembler.h +10 -4
@@ -682,8 +682,12 @@ THUMB( orr \reg , \reg , #PSR_T_BIT )/* * ldr_va - load a 32-bit word from the virtual address of \sym */ - .macro ldr_va, rd:req, sym:req, cond + .macro ldr_va, rd:req, sym:req, cond, tmp + .ifnb \tmp + __ldst_va ldr, \rd, \tmp, \sym, \cond + .else __ldst_va ldr, \rd, \rd, \sym, \cond + .endif .endm/*
@@ -717,9 +721,11 @@ THUMB( orr \reg , \reg , #PSR_T_BIT )* are permitted to overlap with 'rd' if != sp */ .macro ldr_this_cpu, rd:req, sym:req, t1:req, t2:req -#if __LINUX_ARM_ARCH__ >= 7 || \ - !defined(CONFIG_ARM_HAS_GROUP_RELOCS) || \ - (defined(MODULE) && defined(CONFIG_ARM_MODULE_PLTS)) +#ifndef CONFIG_SMP + ldr_va \rd, \sym, tmp=\t1 +#elif __LINUX_ARM_ARCH__ >= 7 || \ + !defined (CONFIG_ARM_HAS_GROUP_RELOCS ) || \ + (defined (MODULE ) &&defined (CONFIG_ARM_MODULE_PLTS )) this_cpu_offset \t1 mov_l \t2, \sym ldr \rd, [\t1, \t2]
Signature · 7 lines
2.30.2 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
cover ARM: optimize some variable accesses
Now that we have an efficient way to load variables from asm code on any arch revision, get rid of any explicit literals that are no longer needed (#2). Patch #1 tweaks the !SMP case for ldr_this_cpu, which uses the same macros.
Ard Biesheuvel (2):
ARM: assembler: simplify ldr_this_cpu for !SMP builds
ARM: entry: avoid explicit literal loads
arch/arm/include/asm/assembler.h | 28 +++++++++------ arch/arm/kernel/entry-armv.S | 37 ++++---------------- arch/arm/kernel/entry-common.S | 10 +----- arch/arm/kernel/entry-header.S | 3 +- 4 files changed, 26 insertions(+), 52 deletions(-)
Signature · 7 lines
2.30.2 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
PATCH 2/2 ARM: entry: avoid explicit literal loads
ARMv7 has MOVW/MOVT instruction pairs to load symbol addresses into registers without having to rely on literal loads that go via the D-cache. For older cores, we now support a similar arrangement, based on PC-relative group relocations.
This means we can elide most literal loads entirely from the entry path, by switching to the ldr_va macro to emit the appropriate sequence depending on the target architecture revision.
While at it, switch to the bl_r macro for invoking the right PABT/DABT helpers instead of setting the LR register explicitly, which does not play well with cores that speculate across function returns.
--- arch/arm/include/asm/assembler.h | 18 +++++----- arch/arm/kernel/entry-armv.S | 37 ++++---------------- arch/arm/kernel/entry-common.S | 10 +----- arch/arm/kernel/entry-header.S | 3 +- 4 files changed, 18 insertions(+), 50 deletions(-)
arch/arm/include/asm/assembler.h +9 -9
@@ -656,12 +656,11 @@ THUMB( orr \reg , \reg , #PSR_T_BIT ) __adldst_l str, \src, \sym, \tmp, \cond .endm - .macro __ldst_va, op, reg, tmp, sym, cond + .macro __ldst_va, op, reg, tmp, sym, cond, offset #if __LINUX_ARM_ARCH__ >= 7 || \ !defined(CONFIG_ARM_HAS_GROUP_RELOCS) || \ (defined(MODULE) && defined(CONFIG_ARM_MODULE_PLTS)) mov_l \tmp, \sym, \cond - \op\cond \reg, [\tmp] #else/* * Avoid a literal load, by emitting a sequence of ADD/LDR instructions
@@ -673,20 +672,21 @@ THUMB( orr \reg , \reg , #PSR_T_BIT ) .reloc .L0_\@, R_ARM_ALU_PC_G0_NC, \sym .reloc .L1_\@, R_ARM_ALU_PC_G1_NC, \sym .reloc .L2_\@, R_ARM_LDR_PC_G2, \sym -.L0_\@: sub\cond \tmp, pc, #8 -.L1_\@: sub\cond \tmp, \tmp, #4 -.L2_\@: \op\cond \reg, [\tmp, #0] +.L0_\@: sub\cond \tmp, pc, #8 - \offset +.L1_\@: sub\cond \tmp, \tmp, #4 - \offset +.L2_\@: #endif + \op\cond \reg, [\tmp, #\offset] .endm /* * ldr_va - load a 32-bit word from the virtual address of \sym */ - .macro ldr_va, rd:req, sym:req, cond, tmp + .macro ldr_va, rd:req, sym:req, cond, tmp, offset=0 .ifnb \tmp - __ldst_va ldr, \rd, \tmp, \sym, \cond + __ldst_va ldr, \rd, \tmp, \sym, \cond, \offset .else - __ldst_va ldr, \rd, \rd, \sym, \cond + __ldst_va ldr, \rd, \rd, \sym, \cond, \offset .endif .endm
@@ -694,7 +694,7 @@ THUMB( orr \reg , \reg , #PSR_T_BIT )* str_va - store a 32-bit word to the virtual address of \sym */ .macro str_va, rn:req, sym:req, tmp:req, cond - __ldst_va str, \rn, \tmp, \sym, \cond + __ldst_va str, \rn, \tmp, \sym, \cond, 0 .endm/*
arch/arm/kernel/entry-armv.S +7 -30
@@ -90,9 +90,8 @@ UNWIND( .setfp fpreg, sp ) .macro pabt_helper @ PABORT handler takes pt_regs in r2, fault address in r4 and psr in r5 #ifdef MULTI_PABORT - ldr ip, .LCprocfns - mov lr, pc - ldr pc, [ip, #PROCESSOR_PABT_FUNC] + ldr_va ip, processor, offset=PROCESSOR_PABT_FUNC + bl_r ip #else bl CPU_PABORT_HANDLER #endif
@@ -111,9 +110,8 @@ UNWIND( .setfp fpreg, sp ) @ the fault status register in r1. r9 must be preserved. @ #ifdef MULTI_DABORT - ldr ip, .LCprocfns - mov lr, pc - ldr pc, [ip, #PROCESSOR_DABT_FUNC] + ldr_va ip, processor, offset=PROCESSOR_DABT_FUNC + bl_r ip #else bl CPU_DABORT_HANDLER #endif
@@ -331,16 +329,6 @@ __fiq_svc: UNWIND(.fnend ) ENDPROC(__fiq_svc) - .align 5 -.LCcralign: - .word cr_alignment -#ifdef MULTI_DABORT -.LCprocfns: - .word processor -#endif -.LCfp: - .word fp_enter - /* * Abort mode handlers */
@@ -399,7 +387,7 @@ ENDPROC(__fiq_abt) THUMB( stmia sp, {r0 - r12} ) ATRAP( mrc p15, 0, r7, c1, c0, 0) - ATRAP( ldr r8, .LCcralign) + ATRAP( ldr_va r8, cr_alignment) ldmia r0, {r3 - r5} add r0, sp, #S_PC @ here for interlock avoidance
@@ -408,8 +396,6 @@ ENDPROC(__fiq_abt) str r3, [sp] @ save the "real" r0 copied @ from the exception stack - ATRAP( ldr r8, [r8, #0]) - @ @ We are now ready to fill in the remaining blanks on the stack: @
@@ -534,9 +520,7 @@ __und_usr_thumb: */ #if __LINUX_ARM_ARCH__ < 7 /* If the target CPU may not be Thumb-2-capable, a run-time check is needed: */ -#define NEED_CPU_ARCHITECTURE - ldr r5, .LCcpu_architecture - ldr r5, [r5] + ldr_va r5, cpu_architecture cmp r5, #CPU_ARCH_ARMv7 blo __und_usr_fault_16 @ 16bit undefined instruction /*
@@ -683,12 +667,6 @@ call_fpe: ret.w lr @ CP#14 (Debug) ret.w lr @ CP#15 (Control) -#ifdef NEED_CPU_ARCHITECTURE - .align 2 -.LCcpu_architecture: - .word __cpu_architecture -#endif - #ifdef CONFIG_NEON .align 6
@@ -714,9 +692,8 @@ call_fpe: #endif do_fpe: - ldr r4, .LCfp add r10, r10, #TI_FPSTATE @ r10 = workspace - ldr pc, [r4] @ Call FP module USR entry point + ldr_va pc, fp_enter, tmp=r4 @ Call FP module USR entry point /* * The FP module is called with these registers set:
arch/arm/kernel/entry-common.S +1 -9
@@ -174,7 +174,7 @@ ENTRY(vector_swi) #endif reload_current r10, ip zero_fp - alignment_trap r10, ip, __cr_alignment + alignment_trap r10, ip, cr_alignment asm_trace_hardirqs_on save=0 enable_irq_notrace ct_user_exit save=0
@@ -304,14 +304,6 @@ __sys_trace_return: bl syscall_trace_exit b ret_slow_syscall - .align 5 -#ifdef CONFIG_ALIGNMENT_TRAP - .type __cr_alignment, #object -__cr_alignment: - .word cr_alignment -#endif - .ltorg - .macro syscall_table_start, sym .equ __sys_nr, 0 .type \sym, #object
arch/arm/kernel/entry-header.S +1 -2
@@ -48,8 +48,7 @@ .macro alignment_trap, rtmp1, rtmp2, label #ifdef CONFIG_ALIGNMENT_TRAP mrc p15, 0, \rtmp2, c1, c0, 0 - ldr \rtmp1, \label - ldr \rtmp1, [\rtmp1] + ldr_va \rtmp1, \label teq \rtmp1, \rtmp2 mcrne p15, 0, \rtmp1, c1, c0, 0 #endif
Signature · 7 lines
2.30.2 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Re: [PATCH 1/2] ARM: assembler: simplify ldr_this_cpu for !SMP builds
In reply to Ard BiesheuvelQuoted 4 lines · Ard Biesheuvel
When
CONFIG_SMPis not defined, the CPU offset is always zero, and so we can simplify the sequence to load a per-CPU variable.Signed-off-by Ard Biesheuvel <[email protected]>
Maybe mention that you add an optional tmp parameter to ldr_va as well?
arch/arm/include/asm/assembler.h THUMB( orr \reg , \reg , #PSR_T_BIT ) · line 685
Quoted 5 lines
/* * ldr_va - load a 32-bit word from the virtual address of \sym */arch/arm/include/asm/assembler.h +1
-1- .macro ldr_va, rd:req, sym:req, cond + .macro ldr_va, rd:req, sym:req, cond, tmp
The text above this macro could explain what cond and tmp are for, took me some time to figure it out.
Anyway, it's not like this code was simple to read in the first place, so:
Yours,
Linus Walleij
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Re: [PATCH 2/2] ARM: entry: avoid explicit literal loads
In reply to Ard BiesheuvelQuoted 9 lines · Ard Biesheuvel
ARMv7 has MOVW/MOVT instruction pairs to load symbol addresses into registers without having to rely on literal loads that go via the D-cache. For older cores, we now support a similar arrangement, based on PC-relative group relocations.
This means we can elide most literal loads entirely from the entry path, by switching to the
ldr_vamacro to emit the appropriate sequence depending on the target architecture revision.
Quoted 5 lines
While at it, switch to the
bl_rmacro for invoking the right PABT/DABT helpers instead of setting the LR register explicitly, which does not play well with cores that speculate across function returns.Signed-off-by Ard Biesheuvel <[email protected]>
After reading the previous patch and figuring out ldr_va this was easier to understand. I guess I'd like some docs around ldr_va ultimately (I only think the top level macros warrant some docs, not say __prefixed inner macros), though offset is quite intuitive anyway the patch makes the kernel a much better place and it's a real beauty so:
Yours,
Linus Walleij
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel