Skip to contentSkip to conversation

sunxi-nand: Undo removal of DMA that breaks NAND SPL

PATCH New Chris Morgan 1 participant 1 message Mar 30, 2022

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 sunxi-nand: Undo removal of DMA that breaks NAND SPL

From: Chris Morgan <[email protected]>

For the sun5i based NAND, removal of the DMA specific code from the SPL driver caused it to no longer function.

These patches revert the changes made here, specifically patches 13/20 and 14/20:
https://lore.kernel.org/u-boot/20210624120540.7oyhdmerjndsylbq@gilmour/

These patches only apply for sun5i based boards. Tested on my NTC CHIP (an R8/A13 based device) and it is able to boot U-Boot properly with these patches.

---
 board/sunxi/board.c                   |   3 +
 drivers/mtd/nand/raw/sunxi_nand_spl.c | 105 ++++++++++++++++++++++++++
 2 files changed, 108 insertions(+)
board/sunxi/board.c +3 -0
index 28f702bc29..289f568415 100644
@@ -393,6 +393,9 @@ static void nand_clock_setup(void)
 #if defined CONFIG_MACH_SUN6I || defined CONFIG_MACH_SUN8I || \
     defined CONFIG_MACH_SUN9I || defined CONFIG_MACH_SUN50I
 	setbits_le32(&ccm->ahb_reset0_cfg, (1 << AHB_GATE_OFFSET_NAND0));
+#endif
+#if defined(CONFIG_MACH_SUN5I) && defined(CONFIG_NAND_SUNXI)
+	setbits_le32(&ccm->ahb_gate0, (1 << AHB_GATE_OFFSET_DMA));
 #endif
 	setbits_le32(&ccm->nand0_clk_cfg, CCM_NAND_CTRL_ENABLE | AHB_DIV_1);
 }
drivers/mtd/nand/raw/sunxi_nand_spl.c +105 -0

129 lines not on this page · raw message

Signature · 1 line
2.30.2