imx: imx8qm-rom7720: switch to binman
Subsystems (3)
PATCH v2 1/1 imx: imx8qm-rom7720: switch to binman
Switch to use binman to pack images
Signed-off-by Oliver Graute <[email protected]>
---
Changes for v2
- just rebased to master
arch/arm/dts/imx8qm-rom7720-a1.dts | 1 + arch/arm/dts/imx8qm-u-boot.dtsi | 133 ++++++++++++++++++ arch/arm/mach-imx/imx8/Kconfig | 1 + .../advantech/imx8qm_rom7720_a1/imximage.cfg | 4 +- configs/imx8qm_rom7720_a1_4G_defconfig | 2 +- doc/board/advantech/imx8qm-rom7720-a1.rst | 3 +- 6 files changed, 139 insertions(+), 5 deletions(-) create mode 100644 arch/arm/dts/imx8qm-u-boot.dtsi
arch/arm/dts/imx8qm-rom7720-a1.dts +1 -0
@@ -10,6 +10,7 @@ /memreserve/ 0x80000000 0x00020000; #include "fsl-imx8qm.dtsi" +#include "imx8qm-u-boot.dtsi" / { model = "Advantech iMX8QM Qseven series";
arch/arm/dts/imx8qm-u-boot.dtsi new file +133 -0
133 lines not on this page · raw message
arch/arm/mach-imx/imx8/Kconfig +1 -0
@@ -81,6 +81,7 @@ config TARGET_CONGA_QMX8 config TARGET_IMX8QM_ROM7720_A1 bool "Support i.MX8QM ROM-7720-A1" + select BINMAN select BOARD_LATE_INIT select SUPPORT_SPL select IMX8QM
board/advantech/imx8qm_rom7720_a1/imximage.cfg +2 -2
@@ -5,8 +5,8 @@ */ -/* Boot from SD, sector size 0x400 */ -BOOT_FROM SD 0x400 +BOOT_FROM sd + /* SoC type IMX8QM */ SOC_TYPE IMX8QM /* Append seco container image */
configs/imx8qm_rom7720_a1_4G_defconfig +1 -1
@@ -18,7 +18,7 @@ CONFIG_SPL=y CONFIG_REMAKE_ELF=y CONFIG_FIT=y CONFIG_SPL_LOAD_FIT=y -CONFIG_SPL_FIT_GENERATOR="arch/arm/mach-imx/mkimage_fit_atf.sh" +# CONFIG_USE_SPL_FIT_GENERATOR is not set CONFIG_BOOTDELAY=3 CONFIG_USE_BOOTCOMMAND=y CONFIG_BOOTCOMMAND="mmc dev ${mmcdev}; if mmc rescan; then if run loadbootscript; then run bootscript; else if run loadimage; then run mmcboot; else run netboot; fi; fi; else booti ${loadaddr} - ${fdt_addr}; fi"
doc/board/advantech/imx8qm-rom7720-a1.rst +1 -2
@@ -57,8 +57,7 @@ Build U-Boot $ export ATF_LOAD_ADDR=0x80000000 $ export BL33_LOAD_ADDR=0x80020000 $ make imx8qm_rom7720_a1_4G_defconfig - $ make u-boot.bin - $ make flash.bin + $ make Flash the binary into the SD card ---------------------------------
Signature · 1 line
2.17.1