dt-bindings: PCI: Add support for Airoha EN7532
Subsystems (5)
PATCH RESEND v10 1/3 dt-bindings: PCI: Add support for Airoha EN7532
From: John Crispin <[email protected]>
EN7532 is an ARM based platform SoC integrating the same PCIe IP as MT7622, add a binding for it.
--- Documentation/devicetree/bindings/pci/mediatek-pcie.txt | 1 + 1 file changed, 1 insertion(+)
Documentation/devicetree/bindings/pci/mediatek-pcie.txt +1 -0
@@ -7,6 +7,7 @@ Required properties: "mediatek,mt7622-pcie" "mediatek,mt7623-pcie" "mediatek,mt7629-pcie" + "airoha,en7523-pcie" - device_type: Must be "pci" - reg: Base addresses and lengths of the root ports. - reg-names: Names of the above areas to use during resource lookup.
Signature · 1 line
2.36.1
PATCH RESEND v10 2/3 PCI: mediatek: Allow building for ARCH_AIROHA
Allow selecting the pcie-mediatek driver if ARCH_AIROHA is set, because the Airoha EN7523 SoC uses the same controller as MT7622.
The driver itself is not modified. The PCIe controller DT node should use mediatek,mt7622-pcie after airoha,en7523-pcie.
--- drivers/pci/controller/Kconfig | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/pci/controller/Kconfig +1 -1
@@ -237,7 +237,7 @@ config PCIE_ROCKCHIP_EP config PCIE_MEDIATEK tristate "MediaTek PCIe controller" - depends on ARCH_MEDIATEK || COMPILE_TEST + depends on ARCH_AIROHA || ARCH_MEDIATEK || COMPILE_TEST depends on OF depends on PCI_MSI_IRQ_DOMAIN help
Signature · 1 line
2.36.1
PATCH RESEND v10 3/3 ARM: dts: Add PCIe support for Airoha EN7523
In reply to Felix FietkauThis uses the MediaTek MT7622 PCIe driver, since the PCIe IP block is nearly identical to the one in MT7622
--- arch/arm/boot/dts/en7523-evb.dts | 8 +++++ arch/arm/boot/dts/en7523.dtsi | 58 ++++++++++++++++++++++++++++++++ 2 files changed, 66 insertions(+)
arch/arm/boot/dts/en7523-evb.dts +8 -0
@@ -33,3 +33,11 @@ &gpio0 { &gpio1 { status = "okay"; }; + +&pcie0 { + status = "okay"; +}; + +&pcie1 { + status = "okay"; +};
arch/arm/boot/dts/en7523.dtsi +58 -0
62 lines not on this page · raw message
Signature · 1 line
2.36.1
Bjorn Helgaas
AppliedQuoted 8 lines · Felix Fietkau
From: John Crispin <[email protected]>
EN7532 is an ARM based platform SoC integrating the same PCIe IP as MT7622, add a binding for it.
Acked-by Rob Herring <[email protected]>Signed-off-by John Crispin <[email protected]>Signed-off-by Felix Fietkau <[email protected]>
Applied patches 1 & 2 to pci/ctrl/mediatek for v5.20, thanks!
I assume patch 3 for:
arch/arm/boot/dts/en7523-evb.dts
arch/arm/boot/dts/en7523.dtsi
needs to go through an ARM tree, right?
Quoted 19 lines
--- Documentation/devicetree/bindings/pci/mediatek-pcie.txt | 1 + 1 file changed, 1 insertion(+)Documentation/devicetree/bindings/pci/mediatek-pcie.txt +1
-0@@ -7,6 +7,7 @@ Required properties: "mediatek,mt7622-pcie" "mediatek,mt7623-pcie" "mediatek,mt7629-pcie" + "airoha,en7523-pcie" - device_type: Must be "pci" - reg: Base addresses and lengths of the root ports. - reg-names: Names of the above areas to use during resource lookup.Signature · 1 line
2.36.1
Re: [PATCH RESEND v10 3/3] ARM: dts: Add PCIe support for Airoha EN7523
In reply to Felix FietkauQuoted 4 lines · Felix Fietkau
This uses the MediaTek MT7622 PCIe driver, since the PCIe IP block is nearly identical to the one in MT7622
Signed-off-by Felix Fietkau <[email protected]>
applied to v5.19-next/dts32
Thanks!
Quoted 88 lines
--- arch/arm/boot/dts/en7523-evb.dts | 8 +++++ arch/arm/boot/dts/en7523.dtsi | 58 ++++++++++++++++++++++++++++++++ 2 files changed, 66 insertions(+)arch/arm/boot/dts/en7523-evb.dts +8
-0@@ -33,3 +33,11 @@ &gpio0 { &gpio1 { status = "okay"; }; + +&pcie0 { + status = "okay"; +}; + +&pcie1 { + status = "okay"; +};arch/arm/boot/dts/en7523.dtsi +58
-0@@ -143,4 +143,62 @@ gpio1: gpio@1fbf0270 { gpio-controller; #gpio-cells = <2>; }; + + pcie0: pcie@1fa91000 { + compatible = "airoha,en7523-pcie", "mediatek,mt7622-pcie"; + device_type = "pci"; + reg = <0x1fa91000 0x1000>; + reg-names = "port0"; + linux,pci-domain = <0>; + #address-cells = <3>; + #size-cells = <2>; + interrupts = <GIC_SPI 39 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "pcie_irq"; + clocks = <&scu EN7523_CLK_PCIE>; + clock-names = "sys_ck0"; + bus-range = <0x00 0xff>; + ranges = <0x82000000 0 0x20000000 0x20000000 0 0x8000000>; + status = "disabled"; + + #interrupt-cells = <1>; + interrupt-map-mask = <0 0 0 7>; + interrupt-map = <0 0 0 1 &pcie_intc0 0>, + <0 0 0 2 &pcie_intc0 1>, + <0 0 0 3 &pcie_intc0 2>, + <0 0 0 4 &pcie_intc0 3>; + pcie_intc0: interrupt-controller { + interrupt-controller; + #address-cells = <0>; + #interrupt-cells = <1>; + }; + }; + + pcie1: pcie@1fa92000 { + compatible = "airoha,en7523-pcie", "mediatek,mt7622-pcie"; + device_type = "pci"; + reg = <0x1fa92000 0x1000>; + reg-names = "port1"; + linux,pci-domain = <1>; + #address-cells = <3>; + #size-cells = <2>; + interrupts = <GIC_SPI 40 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "pcie_irq"; + clocks = <&scu EN7523_CLK_PCIE>; + clock-names = "sys_ck1"; + bus-range = <0x00 0xff>; + ranges = <0x82000000 0 0x28000000 0x28000000 0 0x8000000>; + status = "disabled"; + + #interrupt-cells = <1>; + interrupt-map-mask = <0 0 0 7>; + interrupt-map = <0 0 0 1 &pcie_intc1 0>, + <0 0 0 2 &pcie_intc1 1>, + <0 0 0 3 &pcie_intc1 2>, + <0 0 0 4 &pcie_intc1 3>; + pcie_intc1: interrupt-controller { + interrupt-controller; + #address-cells = <0>; + #interrupt-cells = <1>; + }; + }; };