Create arch/Kconfig.nxp
Hey all,
As I migrate assorted CONFIG options over to Kconfig, a common problem I run in to is that between m68k, PowerPC and ARM (both Layerscape and sometimes i.MX) there are options that fit under more than one architecture but also don't have a good place to go. For example, I just ran in to CONFIG_SYS_FSL_NUM_CC_PLLS which started as PowerPC specific, but is used still in Layerscape and more of a SoC detail (but wouldn't make sense in drivers/soc/Kconfig). I was thinking that perhaps arch/Kconfig.nxp would be a good starting place to put these options, but I'm quite open to other suggestions. Thanks!
Signature · 1 line
Tom
Tom,
I agree to use Kconfig.nxp. thanks for the work.
Thanks,
Peng.
From: Tom Rini <[email protected]>
Sent: 2022年6月16日 2:00
To: [email protected]; Priyanka Jain <[email protected]>; Peng Fan <[email protected]>; Stefano Babic <[email protected]>
Subject: [RFC] Create arch/Kconfig.nxp
Hey all,
As I migrate assorted CONFIG options over to Kconfig, a common problem I run in to is that between m68k, PowerPC and ARM (both Layerscape and sometimes i.MX) there are options that fit under more than one architecture but also don't have a good place to go. For example, I just ran in to CONFIG_SYS_FSL_NUM_CC_PLLS which started as PowerPC specific, but is used still in Layerscape and more of a SoC detail (but wouldn't make sense in drivers/soc/Kconfig). I was thinking that perhaps arch/Kconfig.nxp would be a good starting place to put these options, but I'm quite open to other suggestions. Thanks!
--
Tom
Quoted 9 lines · Tom Rini
Hey all,
As I migrate assorted CONFIG options over to
Kconfig, a common problem I run in to is that between m68k, PowerPC and ARM (both Layerscape and sometimes i.MX) there are options that fit under more than one architecture but also don't have a good place to go. For example, I just ran in toCONFIG_SYS_FSL_NUM_CC_PLLSwhich started as PowerPC specific, but is used still in Layerscape and more of a SoC detail (but wouldn't make sense indrivers/soc/Kconfig).
That's right, there is IP in common that can be factorized.
Quoted 3 lines
I was thinking that
perhapsarch/Kconfig.nxpwould be a good starting place to put these options, but I'm quite open to other suggestions.
+1
It looks to me a good idea ;-)
Regards,
Stefano
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, 82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected] =====================================================================