imx8mq_phanbell: Remove custom CONFIG_SYS_MALLOC_F_LEN
Fabio Estevam
reviewerPATCH 1/1 imx8mq_phanbell: Remove custom CONFIG_SYS_MALLOC_F_LEN
From: Fabio Estevam <[email protected]>
Currently, the imx8mq_phanbell board fails to boot.
Remove the custom CONFIG_SYS_MALLOC_F_LEN setting in favor of the generic one done via the main Kconfig.
Since commit b598957206e5 ("Kconfig: Fix SYS_MALLOC_F_LEN for i.MX8MQ") the default SYS_MALLOC_F_LEN value for i.MX8MQ is 0x2000.
With such default value, the board boots again.
---
Hi Tom,
Maybe you could pick this one directly for the 2022.07 release to fix the boot regression?
Thanks
configs/imx8mq_phanbell_defconfig | 1 - 1 file changed, 1 deletion(-)
configs/imx8mq_phanbell_defconfig +0 -1
@@ -2,7 +2,6 @@ CONFIG_ARM=y CONFIG_ARCH_IMX8M=y CONFIG_SYS_TEXT_BASE=0x40200000 CONFIG_SYS_MALLOC_LEN=0x600000 -CONFIG_SYS_MALLOC_F_LEN=0x4000 CONFIG_SPL_GPIO=y CONFIG_SPL_LIBCOMMON_SUPPORT=y CONFIG_SPL_LIBGENERIC_SUPPORT=y
Signature · 1 line
2.25.1
Quoted 7 lines · Fabio Estevam
From: Fabio Estevam <[email protected]>
Currently, the
imx8mq_phanbellboard fails to boot.Remove the custom
CONFIG_SYS_MALLOC_F_LENsetting in favor of the generic one done via the mainKconfig.
Quoted 6 lines
Since commit
b598957206e5("Kconfig: FixSYS_MALLOC_F_LENfor i.MX8MQ") the defaultSYS_MALLOC_F_LENvalue for i.MX8MQ is0x2000.With such default value, the board boots again.
Signed-off-by Fabio Estevam <[email protected]>
Applied to u-boot/master, thanks!
Signature · 1 line
Tom