sunxi: support half DQ width memory on R40
Subsystems (3)
cover sunxi: support half DQ width memory on R40
On Allwinner boards memory configuration is detected by bootloader. However, R40 (A40i/T3) is somewhat unique because the detection by the DRAM controller via PIR_QSGATE is broken (either in U-Boot or in the controller). So the memory configuration must be detected by other means.
Dual rank detection has been already implemented by Icenowy earlier. This patch extends the automation detection so it can detect half-width DQ configuration (i.e. single x16 DDR3 IC).
Tested on Allwinner A40i-based Wiren Board 7 automation controller, for the following memory configurations:
* 1x 16-bit 4Gbit DDR3, 512 MiB total RAM
* 2x 16-bit 4Gbit DDR3, 1024 MiB total RAM
* 2x 16-bit 8Gbit DDR3, 2048 MiB total RAM
Unfortunately it has NOT been tested with dual-rank configuration yet, as I don't have any dual-rank boards at hand.
I will really appreciate if someone could help me with that.
Evgeny Boger (1):
sunxi: support half DQ width memory on R40
.../include/asm/arch-sunxi/dram_sunxi_dw.h | 1 + arch/arm/mach-sunxi/dram_sunxi_dw.c | 115 ++++++++++++------ 2 files changed, 79 insertions(+), 37 deletions(-)
Signature · 1 line
2.25.1
PATCH 1/1 sunxi: support half DQ width memory on R40
Half DQ width memory configuration is detected in the same way as rank:
by trying to access memory in full-width configuration and checking for timeout error code.
The code is modeled after time_out_detect() routine from a leaked vendor lib-dram u-boot source code. It's very fragile and accessing the wrong memory location in a wrong order will leave the DRAM controller stuck.
Tested on Allwinner A40i-based Wiren Board 7 automation controller, for the following memory configurations:
* 1x 16-bit 4Gbit DDR3, 512 MiB total RAM
* 2x 16-bit 4Gbit DDR3, 1024 MiB total RAM
* 2x 16-bit 8Gbit DDR3, 2048 MiB total RAM
--- .../include/asm/arch-sunxi/dram_sunxi_dw.h | 1 + arch/arm/mach-sunxi/dram_sunxi_dw.c | 115 ++++++++++++------ 2 files changed, 79 insertions(+), 37 deletions(-)
arch/arm/include/asm/arch-sunxi/dram_sunxi_dw.h +1 -0
@@ -193,6 +193,7 @@ struct sunxi_mctl_ctl_reg {#define PIR_INIT (0x1 << 0)/* PHY initialization trigger */ #define PGSR_INIT_DONE (0x1 << 0)/* PHY init done */ +#define PGSR_TIMEOUT (0x1 << 13)/* Timeout error status */ #define ZQCR_PWRDOWN (1U << 31)/* ZQ power down */
arch/arm/mach-sunxi/dram_sunxi_dw.c +78 -37
188 lines not on this page · raw message
Signature · 1 line
2.25.1