Skip to contentSkip to conversation

ina3221: correct the update_interval value

PATCH New Ninad Malwade 1 participant 1 message Oct 7, 2022

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ina3221: correct the update_interval value

As per the INA3221 datasheet the samples value should not be considered while calculating the update_interval value. Section 8.4.2.2 from datasheet says - "The conversion-time settings, along with the programmable-averaging mode, enable the INA3221 to optimize available timing requirements in a given application. For example, if a system requires data to be read every 2 ms with all three channels monitored, configure the INA3221 with the conversion times for the shunt- and bus-voltage measurements set to 332 μs"

As per above only conversion time and number of channels are required to set the update_interval value. Correcting the same in the driver.

---
 Documentation/hwmon/ina3221.rst | 3 +--
 drivers/hwmon/ina3221.c         | 4 +---
 2 files changed, 2 insertions(+), 5 deletions(-)
Documentation/hwmon/ina3221.rst +1 -2
index 8c12c54d2c24..a4f107d1e489 100644
@@ -61,10 +61,9 @@ samples                 Number of samples using in the averaging mode.
 
 update_interval         Data conversion time in millisecond, following:
 
-                          update_interval = C x S x (BC + SC)
+                          update_interval = C x (BC + SC)
 
                           * C:	number of enabled channels
-                          * S:	number of samples
                           * BC:	bus-voltage conversion time in millisecond
                           * SC:	shunt-voltage conversion time in millisecond
 
drivers/hwmon/ina3221.c +1 -3
index 2a57f4b60c29..e3aa57e3b039 100644
@@ -183,11 +183,9 @@ static const int ina3221_avg_samples[] = {
 static inline u32 ina3221_interval_ms_to_conv_time(u16 config, int interval)
 {
 	u32 channels = hweight16(config & INA3221_CONFIG_CHs_EN_MASK);
-	u32 samples_idx = INA3221_CONFIG_AVG(config);
-	u32 samples = ina3221_avg_samples[samples_idx];
 
 	/* Bisect the result to Bus and Shunt conversion times */
-	return DIV_ROUND_CLOSEST(interval * 1000 / 2, channels * samples);
+	return DIV_ROUND_CLOSEST(interval / 2, channels);
 }
 
 /* Converting CONFIG register value to update_interval in usec */
Signature · 1 line
2.17.1