Skip to contentSkip to conversation

doc: ti: Add switch setting for boot modes on AM62 SK

PATCH Andrew Davis 2 participants 2 messages Jan 10, 2023 – Jan 11, 2023 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

Andrew Davis

author Acked-by
#1 lore raw
Quoted 5 lines · Judith Mendez

List some common boot modes and their corresponding switch settings for AM62 SK.

---

Quoted 40 lines
  doc/board/ti/am62x_sk.rst | 29 +++++++++++++++++++++++++++++
  1 file changed, 29 insertions(+)
doc/board/ti/am62x_sk.rst +29 -0
index b1b7d99befb..40d58ea8bfa 100644
@@ -229,3 +229,32 @@ Image formats:
                  | |   SPL DTB 1...N   | |
                  | +-------------------+ |
                  +-----------------------+
+
+Switch Setting for Boot Mode
+----------------------------
+
+Boot Mode pins provide means to select the boot mode and options before the
+device is powered up. After every POR, they are the main source to populate
+the Boot Parameter Tables.
+
+The following table shows some common boot modes used on AM62 platform. More
+details can be found in the Technical Reference Manual:
+https://www.ti.com/lit/pdf/spruiv7 under the `Boot Mode Pins` section.
+
++--------------+------------+------------+
+|*Boot Mode*   | *SW2*      | *SW1*      |
++--------------+------------+------------+
+| Switch label | 12345678   | 12345678   |
++==============+============+============+
+| SD           | 01000000   | 11000010   |
++--------------+------------+------------+
+| OSPI         | 00000000   | 11001110   |
++--------------+------------+------------+
+| EMMC         | 00000000   | 11010010   |
++--------------+------------+------------+
+| UART         | 00000000   | 11011100   |
++--------------+------------+------------+
+| USB DFU      | 00000000   | 11001010   |
++--------------+------------+------------+
+
+For SW2 and SW1, the switch state in the "ON" position = 1.