Support NVIDIA BlueField-3 GPIO controller
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
Linus Walleij
Reviewed-byQuoted 10 lines · Asmaa Mnebhi
This patch adds support for the BlueField-3 SoC GPIO driver which allows:
- setting certain GPIOs as interrupts from other dependent drivers
- ability to manipulate certain GPIO pins via libgpiod toolsBlueField-3 has 56 GPIOs but the user is only allowed to change some of them into GPIO mode. Use
valid_maskto make it impossible to alter the rest of the GPIOs.Signed-off-by Asmaa Mnebhi <[email protected]>
Excellent work Asmaa,
Yours,
Linus Walleij
Asmaa Mnebhi
Reviewed-by Linus WalleijQuoted 5 lines
BlueField-3 has 56 GPIOs but the user is only allowed to change some of them into GPIO mode. Use
valid_maskto make it impossible to alter the rest of the GPIOs.Signed-off-by Asmaa Mnebhi <[email protected]>
Excellent work Asmaa,
Thank you very much Linus!
Andy added few comments which I will address shortly in v4.