Skip to contentSkip to conversation

spi: microchip: pci1xxxx: Fix minor bugs in spi-pci1xxxx driver

PATCH In review Tharun Kumar P 2 participants 2 messages Mar 28, 2023 SPI

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 spi: microchip: pci1xxxx: Fix minor bugs in spi-pci1xxxx driver

Following bugs are fixed in this patch:
1. pci1xxxx_spi_resume API masks SPI interrupt bit which prohibits firing of interrupt to the host at the end of the transaction after suspend-resume. This patch unmasks this bit at resume.
2. In pci1xxxx_spi_transfer_one API, length of SPI transaction gets cleared by unmasking length field. Set length of transaction after unmasking length field.
3. Remove support for disabling chip select as hardware does not support the same.

Fixes 1cc0cbea7167 ("spi: microchip: pci1xxxx: Add driver for SPI controller of PCI1XXXX PCIe switch")
---
 drivers/spi/spi-pci1xxxx.c | 12 ++++--------
 1 file changed, 4 insertions(+), 8 deletions(-)
drivers/spi/spi-pci1xxxx.c +4 -8
index 1c5731641a04..9a044012aca7 100644
@@ -58,7 +58,7 @@
 #define VENDOR_ID_MCHP 0x1055
 
 #define SPI_SUSPEND_CONFIG 0x101
-#define SPI_RESUME_CONFIG 0x303
+#define SPI_RESUME_CONFIG 0x203
 
 struct pci1xxxx_spi_internal {
 	u8 hw_inst;
@@ -114,16 +114,11 @@ static void pci1xxxx_spi_set_cs(struct spi_device *spi, bool enable)
 
 	/* Set the DEV_SEL bits of the SPI_MST_CTL_REG */
 	regval = readl(par->reg_base + SPI_MST_CTL_REG_OFFSET(p->hw_inst));
-	if (enable) {
+	if (!enable) {
 		regval &= ~SPI_MST_CTL_DEVSEL_MASK;
 		regval |= (spi_get_chipselect(spi, 0) << 25);
 		writel(regval,
 		       par->reg_base + SPI_MST_CTL_REG_OFFSET(p->hw_inst));
-	} else {
-		regval &= ~(spi_get_chipselect(spi, 0) << 25);
-		writel(regval,
-		       par->reg_base + SPI_MST_CTL_REG_OFFSET(p->hw_inst));
-
 	}
 }
 
@@ -199,8 +194,9 @@ static int pci1xxxx_spi_transfer_one(struct spi_controller *spi_ctlr,
 			else
 				regval &= ~SPI_MST_CTL_MODE_SEL;
 
-			regval |= ((clkdiv << 5) | SPI_FORCE_CE | (len << 8));
+			regval |= ((clkdiv << 5) | SPI_FORCE_CE);
 			regval &= ~SPI_MST_CTL_CMD_LEN_MASK;
+			regval |= (len << 8);
 			writel(regval, par->reg_base +
 			       SPI_MST_CTL_REG_OFFSET(p->hw_inst));
 			regval = readl(par->reg_base +
Signature · 1 line
2.25.1
maintainer
#1 lore raw
Quoted 9 lines · Tharun Kumar P

Following bugs are fixed in this patch:
1. pci1xxxx_spi_resume API masks SPI interrupt bit which prohibits firing of interrupt to the host at the end of the transaction after suspend-resume. This patch unmasks this bit at resume.
2. In pci1xxxx_spi_transfer_one API, length of SPI transaction gets cleared by unmasking length field. Set length of transaction after unmasking length field.
3. Remove support for disabling chip select as hardware does not support the same.

As covered in submitting-patches.rst you should send one patch per change, this makes things much easier to review.

Quoted 2 lines
 drivers/spi/spi-pci1xxxx.c | 12 ++++--------
 1 file changed, 4 insertions(+), 8 deletions(-)

The subject says this is a patch for the microchip driver...

drivers/spi/spi-pci1xxxx.c static void pci1xxxx_spi_set_cs(struct spi_device *spi, bool enable) · line 126

Quoted 13 lines
drivers/spi/spi-pci1xxxx.c +1 -6
 	/* Set the DEV_SEL bits of the SPI_MST_CTL_REG */
 	regval = readl(par->reg_base + SPI_MST_CTL_REG_OFFSET(p->hw_inst));
-	if (enable) {
+	if (!enable) {
 		regval &= ~SPI_MST_CTL_DEVSEL_MASK;
 		regval |= (spi_get_chipselect(spi, 0) << 25);
 		writel(regval,
 		       par->reg_base + SPI_MST_CTL_REG_OFFSET(p->hw_inst));
-	} else {
-		regval &= ~(spi_get_chipselect(spi, 0) << 25);
-		writel(regval,
-		       par->reg_base + SPI_MST_CTL_REG_OFFSET(p->hw_inst));
-

I am unclear how chip select will ever be asserted with this change? Now the value is only written if we are disabling.