pinctrl: mlxbf3: remove broken Kconfig 'select'

From: Arnd Bergmann <[email protected]>

The new pinctrl driver selects GPIO_MLXBF3, but that can not be enabled yet because the MELLANOX_PLATFORM symbol does not exist in the tree:

WARNING: unmet direct dependencies detected for GPIO_MLXBF3
Depends on [n]: GPIOLIB [=y] && PCI [=n] && (MELLANOX_PLATFORM [=n] && ARM64 [=y] || COMPILE_TEST [=y]) Selected by [y]:
- PINCTRL_MLXBF3 [=y] && PINCTRL [=y] && (MELLANOX_PLATFORM [=n] && ARM64 [=y] || COMPILE_TEST [=y])

As it turns out, the pinctlr driver still builds fine without this, so just remove the select statement.

---
 drivers/pinctrl/Kconfig | 1 -
 1 file changed, 1 deletion(-)

index 77ff9a641aebf..57d57af1f624e 100644
@@ -510,7 +510,6 @@ config PINCTRL_MLXBF3
 	select PINMUX
 	select GPIOLIB
 	select GPIOLIB_IRQCHIP
-	select GPIO_MLXBF3
 	help
 	  Say Y to select the pinctrl driver for BlueField-3 SoCs.
 	  This pin controller allows selecting the mux function for

2.39.2

Patch applied!

Yours,
Linus Walleij