Input: exc3000 - add ACPI support for EXC80H60
Subsystems (2)
PATCH v2 1/1 Input: exc3000 - add ACPI support for EXC80H60
EXC80H60 is used in Ambu aBox2 with ACPI _HID "EGA00001".
Snippet of from "apcidump -b; iasl ssdt2.dat" on target:
Device (TPL2)
{
Name (HID2, Zero)
Name (_HID, "EGA00001") // _HID: Hardware ID
Name (_CID, "PNP0C50" /* HID Protocol Device (I2C bus) */)
// _CID: Compatible ID
Name (_S0W, 0x04) // _S0W: S0 Device Wake State
Name (SBFB, ResourceTemplate ()Signed-off-by Andreas Helbech Kleist <[email protected]>
---
v2:
- Fixed compiler warning reported by kernel test robot
drivers/input/touchscreen/exc3000.c | 10 ++++++++++ 1 file changed, 10 insertions(+)
drivers/input/touchscreen/exc3000.c +10 -0
@@ -7,6 +7,7 @@* minimal implementation based on egalax_ts.c and egalax_i2c.c */ +#include <linux/acpi.h> #include <linux/bitops.h> #include <linux/delay.h> #include <linux/device.h>
@@ -454,10 +455,19 @@ static const struct of_device_id exc3000_of_match[] = {MODULE_DEVICE_TABLE (of, exc3000_of_match);#endif +#ifdef CONFIG_ACPI +static const struct acpi_device_id exc3000_acpi_match[] = { + {"EGA00001" , .driver_data = (kernel_ulong_t)&exc3000_info[EETI_EXC80H60 ] }, + { } +}; +MODULE_DEVICE_TABLE (acpi, exc3000_acpi_match); +#endif +static struct i2c_driver exc3000_driver = { .driver = { .name ="exc3000" , .of_match_table =of_match_ptr (exc3000_of_match), + .acpi_match_table =ACPI_PTR (exc3000_acpi_match), }, .id_table = exc3000_id, .probe_new = exc3000_probe,
Signature · 1 line
2.34.1
Quoted 13 lines · Andreas Helbech Kleist
EXC80H60 is used in Ambu aBox2 with ACPI
_HID"EGA00001".Snippet of from "apcidump -b; iasl ssdt2.dat" on target:
Device (TPL2) { Name (HID2, Zero) Name (_HID, "EGA00001") // _HID: Hardware ID Name (_CID, "PNP0C50" /* HID Protocol Device (I2C bus) */) // _CID: Compatible ID Name (_S0W, 0x04) // _S0W: S0 Device Wake State Name (SBFB, ResourceTemplate ()
Quoted 1 line
Signed-off-by Andreas Helbech Kleist <[email protected]>
Applied, thank you.
Signature · 1 line
Dmitry