Skip to contentSkip to conversation

sh-kexec-refactor-for-kernel-kconfigkexec.patch removed from -mm tree

merged mm-nonmm-stable Andrew Morton 1 participant 1 message Aug 12, 2023

lore
Share & tools
lore

Andrew Morton

author tree notice Applied
#0 lore raw

The quilt patch titled
Subject: sh/kexec: refactor for kernel/Kconfig.kexec
has been removed from the -mm tree. Its filename was
sh-kexec-refactor-for-kernel-kconfigkexec.patch

This patch was dropped because it was merged into the mm-nonmm-stable branch of git://git.kernel.org/pub/scm/linux/kernel/git/akpm/mm

------------------------------------------------------
From: Eric DeVolder <[email protected]>
Subject: sh/kexec: refactor for kernel/Kconfig.kexec
Date: Wed, 12 Jul 2023 12:15:44 -0400

The kexec and crash kernel options are provided in the common kernel/Kconfig.kexec. Utilize the common options and provide the ARCH_SUPPORTS_ and ARCH_SELECTS_ entries to recreate the equivalent set of KEXEC and CRASH options.

---

 arch/sh/Kconfig |   42 ++++++------------------------------------
 1 file changed, 6 insertions(+), 36 deletions(-)
arch/sh/Kconfig renamed from arch/sh/Kconfig~sh-kexec-refactor-for-kernel-kconfigkexec +6 -36
@@ -548,44 +548,14 @@ menu "Kernel features"
 
 source "kernel/Kconfig.hz"
 
-config KEXEC
-	bool "kexec system call (EXPERIMENTAL)"
-	depends on MMU
-	select KEXEC_CORE
-	help
-	  kexec is a system call that implements the ability to shutdown your
-	  current kernel, and to start another kernel.  It is like a reboot
-	  but it is independent of the system firmware.  And like a reboot
-	  you can start any kernel with it, not just Linux.
+config ARCH_SUPPORTS_KEXEC
+	def_bool MMU
 
-	  The name comes from the similarity to the exec system call.
+config ARCH_SUPPORTS_CRASH_DUMP
+	def_bool BROKEN_ON_SMP
 
-	  It is an ongoing process to be certain the hardware in a machine
-	  is properly shutdown, so do not be surprised if this code does not
-	  initially work for you.  As of this writing the exact hardware
-	  interface is strongly in flux, so no good recommendation can be
-	  made.
-
-config CRASH_DUMP
-	bool "kernel crash dumps (EXPERIMENTAL)"
-	depends on BROKEN_ON_SMP
-	help
-	  Generate crash dump after being started by kexec.
-	  This should be normally only set in special crash dump kernels
-	  which are loaded in the main kernel with kexec-tools into
-	  a specially reserved region and then later executed after
-	  a crash by kdump/kexec. The crash dump kernel must be compiled
-	  to a memory address not used by the main kernel using
-	  PHYSICAL_START.
-
-	  For more details see Documentation/admin-guide/kdump/kdump.rst
-
-config KEXEC_JUMP
-	bool "kexec jump (EXPERIMENTAL)"
-	depends on KEXEC && HIBERNATION
-	help
-	  Jump between original kernel and kexeced kernel and invoke
-	  code via KEXEC
+config ARCH_SUPPORTS_KEXEC_JUMP
+	def_bool y
 
 config PHYSICAL_START
 	hex "Physical address where the kernel is loaded" if (EXPERT || CRASH_DUMP)

_

Patches currently in -mm which might be from [email protected] are

crash-move-a-few-code-bits-to-setup-support-of-crash-hotplug.patch crash-add-generic-infrastructure-for-crash-hotplug-support.patch kexec-exclude-elfcorehdr-from-the-segment-digest.patch crash-memory-and-cpu-hotplug-sysfs-attributes.patch x86-crash-add-x86-crash-hotplug-support.patch crash-hotplug-support-for-kexec_load.patch crash-change-crash_prepare_elf64_headers-to-for_each_possible_cpu.patch x86-crash-optimize-cpu-changes.patch