pinctrl: tegra: Display pin function in pinconf-groups
Subsystems (3)
PATCH 1/1 pinctrl: tegra: Display pin function in pinconf-groups
From: Thierry Reding <[email protected]>
The function that a pin is muxed to can be read from the top-level pinctrl-maps debugfs file. However, this only reflects the values that were specified in device tree, so they will only show deviations from the hardware default setting. Display the current pinmux setting in the per-controller pinconf-groups debugfs file along with the rest of the per-pin configuration settings.
--- drivers/pinctrl/tegra/pinctrl-tegra.c | 8 ++++++++ 1 file changed, 8 insertions(+)
drivers/pinctrl/tegra/pinctrl-tegra.c +8 -0
@@ -639,6 +639,14 @@ static void tegra_pinconf_group_dbg_show(struct pinctrl_dev *pctldev,seq_printf (s,"\n\t%s=%u" ,strip_prefix (cfg_params[i].property), val); } + +if (g->mux_reg >=0 ) { +/* read pinmux function and dump to seq_file */ + val =pmx_readl (pmx, g->mux_bank, g->mux_reg); + val = g->funcs[(val >> g->mux_bit) &0x3 ]; + +seq_printf (s,"\n\tfunction=%s" , pmx->functions[val].name); + } } static void tegra_pinconf_config_dbg_show(struct pinctrl_dev *pctldev,
Signature · 1 line
2.42.0
Hello Thierry,
Quoted 10 lines · On Fri, 29 Sep 2023 14:21:01 +0200 Thierry Reding <[email protected]>…
From: Thierry Reding <[email protected]>
The function that a pin is muxed to can be read from the top-level pinctrl-maps debugfs file. However, this only reflects the values that were specified in device tree, so they will only show deviations from the hardware default setting. Display the current pinmux setting in the per-controller pinconf-groups debugfs file along with the rest of the per-pin configuration settings.
Signed-off-by Thierry Reding <[email protected]>
Signature · 3 lines
Luca Ceresoli, Bootlin Embedded Linux and Kernel engineering https://bootlin.com
Quoted 10 lines · Thierry Reding
From: Thierry Reding <[email protected]>
The function that a pin is muxed to can be read from the top-level pinctrl-maps debugfs file. However, this only reflects the values that were specified in device tree, so they will only show deviations from the hardware default setting. Display the current pinmux setting in the per-controller pinconf-groups debugfs file along with the rest of the per-pin configuration settings.
Signed-off-by Thierry Reding <[email protected]>
Patch queued for v6.8, will appear in next when the v6.7-rc1 is released.
Yours,
Linus Walleij