FAILED: Patch "x86/efistub: Call mixed mode boot services on the firmware's stack" failed to apply to 6.8-stable tree
Subsystems (2)
Sasha Levin
maintainerThe patch below does not apply to the 6.8-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.
Thanks,
Sasha
------------------ original commit in Linus's tree ------------------
From cefcd4fe2e3aaf792c14c9e56dab89e3d7a65d02 Mon Sep 17 00:00:00 2001
From: Ard Biesheuvel <[email protected]>
Date: Fri, 22 Mar 2024 17:03:58 +0200
Subject: [PATCH] x86/efistub: Call mixed mode boot services on the firmware's
stack
Normally, the EFI stub calls into the EFI boot services using the stack that was live when the stub was entered. According to the UEFI spec, this stack needs to be at least 128k in size - this might seem large but all asynchronous processing and event handling in EFI runs from the same stack and so quite a lot of space may be used in practice.
In mixed mode, the situation is a bit different: the bootloader calls the 32-bit EFI stub entry point, which calls the decompressor's 32-bit entry point, where the boot stack is set up, using a fixed allocation of 16k. This stack is still in use when the EFI stub is started in 64-bit mode, and so all calls back into the EFI firmware will be using the decompressor's limited boot stack.
Due to the placement of the boot stack right after the boot heap, any stack overruns have gone unnoticed. However, commit
5c4feadb0011983b ("x86/decompressor: Move global symbol references to C code")
moved the definition of the boot heap into C code, and now the boot stack is placed right at the base of BSS, where any overruns will corrupt the end of the .data section.
While it would be possible to work around this by increasing the size of the boot stack, doing so would affect all x86 systems, and mixed mode systems are a tiny (and shrinking) fraction of the x86 installed base.
So instead, record the firmware stack pointer value when entering from the 32-bit firmware, and switch to this stack every time a EFI boot service call is made.
--- arch/x86/boot/compressed/efi_mixed.S | 9 +++++++++ 1 file changed, 9 insertions(+)
arch/x86/boot/compressed/efi_mixed.S +9 -0
@@ -49,6 +49,11 @@ SYM_FUNC_START(startup_64_mixed_mode) lea efi32_boot_args(%rip), %rdx mov 0(%rdx), %edi mov 4(%rdx), %esi + + /* Switch to the firmware's stack */ + movl efi32_boot_sp(%rip), %esp + andl $~7, %esp + #ifdef CONFIG_EFI_HANDOVER_PROTOCOL mov 8(%rdx), %edx // saved bootparams pointer test %edx, %edx
@@ -254,6 +259,9 @@ SYM_FUNC_START_LOCAL(efi32_entry) /* Store firmware IDT descriptor */ sidtl (efi32_boot_idt - 1b)(%ebx) + /* Store firmware stack pointer */ + movl %esp, (efi32_boot_sp - 1b)(%ebx) + /* Store boot arguments */ leal (efi32_boot_args - 1b)(%ebx), %ebx movl %ecx, 0(%ebx)
@@ -318,5 +326,6 @@ SYM_DATA_END(efi32_boot_idt) SYM_DATA_LOCAL(efi32_boot_cs, .word 0) SYM_DATA_LOCAL(efi32_boot_ds, .word 0) +SYM_DATA_LOCAL(efi32_boot_sp, .long 0) SYM_DATA_LOCAL(efi32_boot_args, .long 0, 0, 0) SYM_DATA(efi_is64, .byte 1)
Signature · 1 line
2.43.0
Quoted 6 lines · Sasha Levin
The patch below does not apply to the 6.8-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.
This applies fine on top of 6.8.2, 6.7.11 and 6.6.23.
On 6.1.83, it gave me a warning
Auto-merging arch/x86/boot/compressed/efi_mixed.S
but the change still applied without problems.
Not sure what is going on here .....
Quoted 83 lines
------------------ original commit in Linus's tree ------------------
From
cefcd4fe2e3aaf792c14c9e56dab89e3d7a65d02Mon Sep 17 00:00:00 2001
From: Ard Biesheuvel <[email protected]>
Date: Fri, 22 Mar 2024 17:03:58 +0200
Subject: [PATCH] x86/efistub: Call mixed mode boot services on the firmware's
stackNormally, the EFI stub calls into the EFI boot services using the stack that was live when the stub was entered. According to the UEFI spec, this stack needs to be at least 128k in size - this might seem large but all asynchronous processing and event handling in EFI runs from the same stack and so quite a lot of space may be used in practice.
In mixed mode, the situation is a bit different: the bootloader calls the 32-bit EFI stub entry point, which calls the decompressor's 32-bit entry point, where the boot stack is set up, using a fixed allocation of 16k. This stack is still in use when the EFI stub is started in 64-bit mode, and so all calls back into the EFI firmware will be using the decompressor's limited boot stack.
Due to the placement of the boot stack right after the boot heap, any stack overruns have gone unnoticed. However, commit
5c4feadb0011983b("x86/decompressor: Move global symbol references to C code")moved the definition of the boot heap into C code, and now the boot stack is placed right at the base of BSS, where any overruns will corrupt the end of the .data section.
While it would be possible to work around this by increasing the size of the boot stack, doing so would affect all x86 systems, and mixed mode systems are a tiny (and shrinking) fraction of the x86 installed base.
So instead, record the firmware stack pointer value when entering from the 32-bit firmware, and switch to this stack every time a EFI boot service call is made.
Cc <[email protected]> # v6.1+Signed-off-by Ard Biesheuvel <[email protected]>--- arch/x86/boot/compressed/efi_mixed.S | 9 +++++++++ 1 file changed, 9 insertions(+)arch/x86/boot/compressed/efi_mixed.S +9
-1@@ -49,6 +49,11 @@ SYM_FUNC_START(startup_64_mixed_mode) lea efi32_boot_args(%rip), %rdx mov 0(%rdx), %edi mov 4(%rdx), %esi + + /* Switch to the firmware's stack */ + movl efi32_boot_sp(%rip), %esp + andl $~7, %esp + #ifdef CONFIG_EFI_HANDOVER_PROTOCOL mov 8(%rdx), %edx // saved bootparams pointer test %edx, %edx@@ -254,6 +259,9 @@ SYM_FUNC_START_LOCAL(efi32_entry) /* Store firmware IDT descriptor */ sidtl (efi32_boot_idt - 1b)(%ebx) + /* Store firmware stack pointer */ + movl %esp, (efi32_boot_sp - 1b)(%ebx) + /* Store boot arguments */ leal (efi32_boot_args - 1b)(%ebx), %ebx movl %ecx, 0(%ebx)@@ -318,5 +326,6 @@ SYM_DATA_END(efi32_boot_idt) SYM_DATA_LOCAL(efi32_boot_cs, .word 0) SYM_DATA_LOCAL(efi32_boot_ds, .word 0) +SYM_DATA_LOCAL(efi32_boot_sp, .long 0) SYM_DATA_LOCAL(efi32_boot_args, .long 0, 0, 0) SYM_DATA(efi_is64, .byte 1) --2.43.0
Quoted 11 lines · Ard Biesheuvel
Quoted 6 lines · Sasha Levin
The patch below does not apply to the 6.8-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.This applies fine on top of 6.8.2, 6.7.11 and 6.6.23.
Quoted 8 lines
On 6.1.83, it gave me a warning
Auto-merging
arch/x86/boot/compressed/efi_mixed.Sbut the change still applied without problems.
Not sure what is going on here .....
Ping?
Greg KH
maintainerQuoted 14 lines · Ard Biesheuvel
Quoted 13 lines · Ard Biesheuvel
Quoted 6 lines · Sasha Levin
The patch below does not apply to the 6.8-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.This applies fine on top of 6.8.2, 6.7.11 and 6.6.23.
On 6.1.83, it gave me a warning
Quoted 9 lines
Quoted 6 lines
Auto-merging
arch/x86/boot/compressed/efi_mixed.Sbut the change still applied without problems.
Not sure what is going on here .....
Ping?
Give us time to catch up please, I'll go look at this now...
Greg KH
maintainerQuoted 10 lines · Ard Biesheuvel
Quoted 6 lines · Sasha Levin
The patch below does not apply to the 6.8-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.This applies fine on top of 6.8.2, 6.7.11 and 6.6.23.
Quoted 7 lines
On 6.1.83, it gave me a warning
Auto-merging
arch/x86/boot/compressed/efi_mixed.Sbut the change still applied without problems.
Not sure what is going on here .....
Odd, it worked here forme, now queued up everywhere, sorry for the noise.
greg k-h
Quoted 14 lines · Greg KH
Quoted 12 lines · Ard Biesheuvel
Quoted 6 lines · Sasha Levin
The patch below does not apply to the 6.8-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.This applies fine on top of 6.8.2, 6.7.11 and 6.6.23.
On 6.1.83, it gave me a warning
Quoted 9 lines
Quoted 5 lines
Auto-merging
arch/x86/boot/compressed/efi_mixed.Sbut the change still applied without problems.
Not sure what is going on here .....
Odd, it worked here forme, now queued up everywhere, sorry for the noise.
Thanks!