PCI: hotplug: Use atomic_{fetch_}andnot() where appropriate
PATCH 1/1 PCI: hotplug: Use atomic_{fetch_}andnot() where appropriate
Use atomic_{fetch_}andnot(i, v) instead of atomic_{fetch_}and(~i, v).
No functional changes intended.
--- drivers/pci/hotplug/pciehp_ctrl.c | 4 ++-- drivers/pci/hotplug/pciehp_hpc.c | 8 ++++---- 2 files changed, 6 insertions(+), 6 deletions(-)
drivers/pci/hotplug/pciehp_ctrl.c +2 -2
@@ -121,8 +121,8 @@ static void remove_board(struct controller *ctrl, bool safe_removal)msleep (1000 );/* Ignore link or presence changes caused by power off */ -atomic_and (~(PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC ), - &ctrl->pending_events); +atomic_andnot (PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC , + &ctrl->pending_events); } pciehp_set_indicators(ctrl, PCI_EXP_SLTCTL_PWR_IND_OFF,
drivers/pci/hotplug/pciehp_hpc.c +4 -4
@@ -307,8 +307,8 @@ int pciehp_check_link_status(struct controller *ctrl)/* ignore link or presence changes up to this point */ if (found) -atomic_and (~(PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC ), - &ctrl->pending_events); +atomic_andnot (PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC , + &ctrl->pending_events);pcie_capability_read_word (pdev,PCI_EXP_LNKSTA , &lnk_status);ctrl_dbg (ctrl,"%s: lnk_status = %x\n" , __func__, lnk_status);
@@ -568,7 +568,7 @@ static void pciehp_ignore_dpc_link_change(struct controller *ctrl,* Could be several if DPC triggered multiple times consecutively. */ synchronize_hardirq (irq); -atomic_and (~PCI_EXP_SLTSTA_DLLSC , &ctrl->pending_events); +atomic_andnot (PCI_EXP_SLTSTA_DLLSC , &ctrl->pending_events);if (pciehp_poll_mode)pcie_capability_write_word (pdev,PCI_EXP_SLTSTA ,PCI_EXP_SLTSTA_DLLSC );
@@ -702,7 +702,7 @@ static irqreturn_t pciehp_ist(int irq, void *dev_id)pci_config_pm_runtime_get (pdev);/* rerun pciehp_isr() if the port was inaccessible on interrupt */ -if (atomic_fetch_and (~RERUN_ISR , &ctrl->pending_events) &RERUN_ISR ) { +if (atomic_fetch_andnot (RERUN_ISR , &ctrl->pending_events) &RERUN_ISR ) { ret =pciehp_isr (irq, dev_id);enable_irq (irq);if (ret !=IRQ_WAKE_THREAD )
Signature · 1 line
2.45.2
[+cc Lukas, Ilpo]
Quoted 1 line · Uros Bizjak
Use atomic_{fetch_}andnot(i, v) instead of atomic_{fetch_}and(~i, v).
If the purpose is to improve readability, let's mention that here. Since this only touches pciehp, make the subject line "PCI: pciehp:
..." as was done in the past.
It looks like every use of atomic_and() uses a ~value and is hence a candidate for a similar change, but I'm not sure that converting to "andnot" and removing the explicit bitwise NOT is really a readability benefit.
If it were named something like "atomic_clear_bits", I'd be totally in favor since that's a little higher-level description, but that ship has long since sailed.
But I don't really care and if this is the trend, I'm fine with this if Lukas and Ilpo agree.
Quoted 60 lines
No functional changes intended.
Cc Bjorn Helgaas <[email protected]>Signed-off-by Uros Bizjak <[email protected]>--- drivers/pci/hotplug/pciehp_ctrl.c | 4 ++-- drivers/pci/hotplug/pciehp_hpc.c | 8 ++++---- 2 files changed, 6 insertions(+), 6 deletions(-)drivers/pci/hotplug/pciehp_ctrl.c +2
-2@@ -121,8 +121,8 @@ static void remove_board(struct controller *ctrl, bool safe_removal)msleep (1000 );/* Ignore link or presence changes caused by power off */ -atomic_and (~(PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC ), - &ctrl->pending_events); +atomic_andnot (PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC , + &ctrl->pending_events); } pciehp_set_indicators(ctrl, PCI_EXP_SLTCTL_PWR_IND_OFF,drivers/pci/hotplug/pciehp_hpc.c +4
-4@@ -307,8 +307,8 @@ int pciehp_check_link_status(struct controller *ctrl)/* ignore link or presence changes up to this point */ if (found) -atomic_and (~(PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC ), - &ctrl->pending_events); +atomic_andnot (PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC , + &ctrl->pending_events);pcie_capability_read_word (pdev,PCI_EXP_LNKSTA , &lnk_status);ctrl_dbg (ctrl,"%s: lnk_status = %x\n" , __func__, lnk_status);@@ -568,7 +568,7 @@ static void pciehp_ignore_dpc_link_change(struct controller *ctrl,* Could be several if DPC triggered multiple times consecutively. */ synchronize_hardirq (irq); -atomic_and (~PCI_EXP_SLTSTA_DLLSC , &ctrl->pending_events); +atomic_andnot (PCI_EXP_SLTSTA_DLLSC , &ctrl->pending_events);if (pciehp_poll_mode)pcie_capability_write_word (pdev,PCI_EXP_SLTSTA ,PCI_EXP_SLTSTA_DLLSC );@@ -702,7 +702,7 @@ static irqreturn_t pciehp_ist(int irq, void *dev_id)pci_config_pm_runtime_get (pdev);/* rerun pciehp_isr() if the port was inaccessible on interrupt */ -if (atomic_fetch_and (~RERUN_ISR , &ctrl->pending_events) &RERUN_ISR ) { +if (atomic_fetch_andnot (RERUN_ISR , &ctrl->pending_events) &RERUN_ISR ) { ret =pciehp_isr (irq, dev_id);enable_irq (irq);if (ret !=IRQ_WAKE_THREAD )Signature · 1 line
2.45.2
Quoted 14 lines · Bjorn Helgaas
[+cc Lukas, Ilpo]
Quoted 1 line · Uros Bizjak
Use atomic_{fetch_}andnot(i, v) instead of atomic_{fetch_}and(~i, v).
If the purpose is to improve readability, let's mention that here. Since this only touches pciehp, make the subject line "PCI: pciehp:
..." as was done in the past.It looks like every use of
atomic_and()uses a ~value and is hence a candidate for a similar change, but I'm not sure that converting to "andnot" and removing the explicit bitwise NOT is really a readability benefit.
Quoted 6 lines
If it were named something like "
atomic_clear_bits", I'd be totally in favor since that's a little higher-level description, but that ship has long since sailed.But I don't really care and if this is the trend, I'm fine with this if Lukas and Ilpo agree.
I'm pretty much aligned with Bjorn, I don't find it clearer but I don't feel too strongly now that I've seen how to interpret this. As he pointed out, there would have been much better names for this operation ("andnot" feels similar to using double negations which easily gets confusing unless one maps it inside head into positive logic).
Signature · 1 line
i.
Quoted 61 lines
Quoted 60 lines
No functional changes intended.
Cc Bjorn Helgaas <[email protected]>Signed-off-by Uros Bizjak <[email protected]>--- drivers/pci/hotplug/pciehp_ctrl.c | 4 ++-- drivers/pci/hotplug/pciehp_hpc.c | 8 ++++---- 2 files changed, 6 insertions(+), 6 deletions(-)drivers/pci/hotplug/pciehp_ctrl.c +2
-2@@ -121,8 +121,8 @@ static void remove_board(struct controller *ctrl, bool safe_removal)msleep (1000 );/* Ignore link or presence changes caused by power off */ -atomic_and (~(PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC ), - &ctrl->pending_events); +atomic_andnot (PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC , + &ctrl->pending_events); } pciehp_set_indicators(ctrl, PCI_EXP_SLTCTL_PWR_IND_OFF,drivers/pci/hotplug/pciehp_hpc.c +4
-4@@ -307,8 +307,8 @@ int pciehp_check_link_status(struct controller *ctrl)/* ignore link or presence changes up to this point */ if (found) -atomic_and (~(PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC ), - &ctrl->pending_events); +atomic_andnot (PCI_EXP_SLTSTA_DLLSC |PCI_EXP_SLTSTA_PDC , + &ctrl->pending_events);pcie_capability_read_word (pdev,PCI_EXP_LNKSTA , &lnk_status);ctrl_dbg (ctrl,"%s: lnk_status = %x\n" , __func__, lnk_status);@@ -568,7 +568,7 @@ static void pciehp_ignore_dpc_link_change(struct controller *ctrl,* Could be several if DPC triggered multiple times consecutively. */ synchronize_hardirq (irq); -atomic_and (~PCI_EXP_SLTSTA_DLLSC , &ctrl->pending_events); +atomic_andnot (PCI_EXP_SLTSTA_DLLSC , &ctrl->pending_events);if (pciehp_poll_mode)pcie_capability_write_word (pdev,PCI_EXP_SLTSTA ,PCI_EXP_SLTSTA_DLLSC );@@ -702,7 +702,7 @@ static irqreturn_t pciehp_ist(int irq, void *dev_id)pci_config_pm_runtime_get (pdev);/* rerun pciehp_isr() if the port was inaccessible on interrupt */ -if (atomic_fetch_and (~RERUN_ISR , &ctrl->pending_events) &RERUN_ISR ) { +if (atomic_fetch_andnot (RERUN_ISR , &ctrl->pending_events) &RERUN_ISR ) { ret =pciehp_isr (irq, dev_id);enable_irq (irq);if (ret !=IRQ_WAKE_THREAD )Signature · 1 line
2.45.2
Quoted 10 lines · Bjorn Helgaas
[+cc Lukas, Ilpo]
Quoted 1 line · Uros Bizjak
Use atomic_{fetch_}andnot(i, v) instead of atomic_{fetch_}and(~i, v).
If the purpose is to improve readability, let's mention that here. Since this only touches pciehp, make the subject line "PCI: pciehp:
..." as was done in the past.
Quoted 8 lines
It looks like every use of
atomic_and()uses a ~value and is hence a candidate for a similar change, but I'm not sure that converting to "andnot" and removing the explicit bitwise NOT is really a readability benefit.If it were named something like "
atomic_clear_bits", I'd be totally in favor since that's a little higher-level description, but that ship has long since sailed.
FYI, the set of atomic primitives and their corresponding names have quite a long history. These are based on IA-64 psABI [1, section 7.4] when this particular primitive was named __sync_nand_and_fetch/__sync_fetch_and_nand. Even GCC got the and-not part wrong (it implemented it as not-and in some ancient version), so luckily the kernel named it atomic_{fetch_}andnot.
As far as the patch is concerned, some architectures emit atomic andnot instruction. In the proposed patch, we have a constant argument to atomic_and, and the compiler is smart enough to apply the bitwise not to the argument and emits an inverted constant argument. So, in reality, the same code is produced.
x86 with BMI1 ISA extension provides ANDN instruction, but it can't be used with LOCK prefix.
So, if there is no readability benefit, it is OK with me to drop the patch.
[1] https://refspecs.linuxfoundation.org/elf/IA64-SysV-psABI.pdf
Thanks,
Uros.