Skip to contentSkip to conversation

ARM: imx: Enable SPL DTO application support for i.MX8MP DHCOM PDK2

PATCH In review Marek Vasut 2 participants 2 messages Jun 23, 2024 – Jun 24, 2024

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ARM: imx: Enable SPL DTO application support for i.MX8MP DHCOM PDK2

Enable SPL DTO support to apply matching SoM specific DTOs to cater for the SoM differences in DH i.MX8MP DHCOM PDK2 configuration. This is already enabled in DH i.MX8MP DHCOM PDK3 configuration so align the two configurations.

Fixes ad1158c50e0e ("arm64: dts: imx8mp: Switch to DT overlays for i.MX8MP DHCOM SoM")

---
Cc: Fabio Estevam <[email protected]>
Cc: Tom Rini <[email protected]>
Cc: [email protected]
Cc: [email protected]

---
 configs/imx8mp_dhcom_pdk2_defconfig | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)
configs/imx8mp_dhcom_pdk2_defconfig +2 -1
index e5d74a9bdb2..cbc608dd912 100644
@@ -15,7 +15,6 @@ CONFIG_DM_GPIO=y
 CONFIG_DEFAULT_DEVICE_TREE="imx8mp-dhcom-pdk2"
 CONFIG_SPL_TEXT_BASE=0x920000
 CONFIG_TARGET_IMX8MP_DH_DHCOM_PDK2=y
-CONFIG_OF_LIBFDT_OVERLAY=y
 CONFIG_DM_RESET=y
 CONFIG_SYS_MONITOR_LEN=1048576
 CONFIG_SPL_MMC=y
@@ -41,6 +40,7 @@ CONFIG_FIT=y
 CONFIG_FIT_EXTERNAL_OFFSET=0x3000
 CONFIG_SPL_LOAD_FIT=y
 CONFIG_SPL_LOAD_FIT_ADDRESS=0x44000000
+CONFIG_SPL_LOAD_FIT_APPLY_OVERLAY=y
 CONFIG_SYS_BOOTM_LEN=0x8000000
 CONFIG_SUPPORT_RAW_INITRD=y
 CONFIG_OF_SYSTEM_SETUP=y
@@ -66,6 +66,7 @@ CONFIG_SPL_CUSTOM_SYS_MALLOC_ADDR=0x4c000000
 CONFIG_SPL_SYS_MALLOC_SIZE=0x80000
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x300
+# CONFIG_SPL_FIT_IMAGE_TINY is not set
 CONFIG_SPL_I2C=y
 CONFIG_SPL_POWER=y
 CONFIG_SPL_WATCHDOG=y
Signature · 1 line
2.43.0
reviewer
#1 lore raw
Quoted 8 lines · Marek Vasut

Enable SPL DTO support to apply matching SoM specific DTOs to cater for the SoM differences in DH i.MX8MP DHCOM PDK2 configuration. This is already enabled in DH i.MX8MP DHCOM PDK3 configuration so align the two configurations.

Fixes ad1158c50e0e ("arm64: dts: imx8mp: Switch to DT overlays for i.MX8MP DHCOM SoM")

Applied to u-boot-imx/next, thanks.