net: ftgmac100: Fixed NC-SI PHY device cannot get
PATCH 1/1 net: ftgmac100: Fixed NC-SI PHY device cannot get
The NC-SI interface does not need the MDIO bus and the NC-SI PHY device cannot get from dm_eth_phy_connect. Therefore, use phy_connect directly here.
Signed-off-by Jacky Chou <[email protected]>
--- drivers/net/ftgmac100.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/net/ftgmac100.c +1 -1
@@ -223,7 +223,7 @@ static int ftgmac100_phy_init(struct udevice *dev)struct phy_device *phydev;int ret; -if (IS_ENABLED (CONFIG_DM_MDIO )) +if (IS_ENABLED (CONFIG_DM_MDIO ) && priv->phy_mode !=PHY_INTERFACE_MODE_NCSI ) phydev =dm_eth_phy_connect (dev);else phydev =phy_connect (priv->bus, priv->phy_addr, dev, priv->phy_mode);
Signature · 1 line
2.25.1
Quoted 8 lines · Jacky Chou
The NC-SI interface does not need the MDIO bus and the NC-SI PHY device cannot get from
dm_eth_phy_connect. Therefore, usephy_connectdirectly here.Signed-off-by Jacky Chou <[email protected]>--- drivers/net/ftgmac100.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
Acked-by Leo Yu-Chi Liang <[email protected]>