dt-bindings: fpga: altr,fpga-passive-serial: Convert to yaml
Subsystems (2)
PATCH RESEND 1/1 dt-bindings: fpga: altr,fpga-passive-serial: Convert to yaml
From: Fabio Estevam <[email protected]>
Convert the Altera Passive Serial SPI FPGA Manager binding from text file to yaml format to allow devicetree validation.
Signed-off-by Fabio Estevam <[email protected]>
Reviewed-by Conor Dooley <[email protected]>
--- .../bindings/fpga/altera-passive-serial.txt | 29 -------- .../fpga/altr,fpga-passive-serial.yaml | 74 +++++++++++++++++++ 2 files changed, 74 insertions(+), 29 deletions(-) delete mode 100644 Documentation/devicetree/bindings/fpga/altera-passive-serial.txt create mode 100644 Documentation/devicetree/bindings/fpga/altr,fpga-passive-serial.yaml
Documentation/devicetree/bindings/fpga/altera-passive-serial.txt deleted +0 -29
@@ -1,29 +0,0 @@ -Altera Passive Serial SPI FPGA Manager - -Altera FPGAs support a method of loading the bitstream over what is -referred to as "passive serial". -The passive serial link is not technically SPI, and might require extra -circuits in order to play nicely with other SPI slaves on the same bus. - -See https://www.altera.com/literature/hb/cyc/cyc_c51013.pdf - -Required properties: -- compatible: Must be one of the following: - "altr,fpga-passive-serial", - "altr,fpga-arria10-passive-serial" -- reg: SPI chip select of the FPGA -- nconfig-gpios: config pin (referred to as nCONFIG in the manual) -- nstat-gpios: status pin (referred to as nSTATUS in the manual) - -Optional properties: -- confd-gpios: confd pin (referred to as CONF_DONE in the manual) - -Example: - fpga: fpga@0 { - compatible = "altr,fpga-passive-serial"; - spi-max-frequency = <20000000>; - reg = <0>; - nconfig-gpios = <&gpio4 9 GPIO_ACTIVE_LOW>; - nstat-gpios = <&gpio4 11 GPIO_ACTIVE_LOW>; - confd-gpios = <&gpio4 12 GPIO_ACTIVE_LOW>; - };
Documentation/devicetree/bindings/fpga/altr,fpga-passive-serial.yaml new file +74 -0
74 lines not on this page · raw message
Signature · 1 line
2.34.1
Quoted 5 lines · Fabio Estevam
From: Fabio Estevam <[email protected]>
Convert the Altera Passive Serial SPI FPGA Manager binding from text file to yaml format to allow devicetree validation.
Quoted 9 lines
Signed-off-by Fabio Estevam <[email protected]>Reviewed-by Conor Dooley <[email protected]>--- .../bindings/fpga/altera-passive-serial.txt | 29 -------- .../fpga/altr,fpga-passive-serial.yaml | 74 +++++++++++++++++++ 2 files changed, 74 insertions(+), 29 deletions(-) delete mode 100644 Documentation/devicetree/bindings/fpga/altera-passive-serial.txt create mode 100644 Documentation/devicetree/bindings/fpga/altr,fpga-passive-serial.yaml
Applied, thanks!