X1E Dell XPS 9345 Improvements 1
cover X1E Dell XPS 9345 Improvements 1
First round of improvements.
* Add experimentally discovered edp enable gpio. Drop panel info, as it is now documented in [1]
* Add Johan Hovold's fix for nvme regulator
[1] https://lore.kernel.org/all/CAD=FV=Wu3vaY4Rtw4OZwgAf_b44JpDsKJhUa-EXiuu1hn3aJoQ@mail.gmail.com/
Aleksandrs Vinarskis (2):
arm64: dts: qcom: x1e80100-dell-xps13-9345: route edp-panel enable
gpio
arm64: dts: qcom: x1e80100-dell-xps13-9345: fix nvme regulator boot
glitch
.../boot/dts/qcom/x1e80100-dell-xps13-9345.dts | 14 +++++++++++++- 1 file changed, 13 insertions(+), 1 deletion(-)
Signature · 1 line
2.45.2
PATCH 1/2 arm64: dts: qcom: x1e80100-dell-xps13-9345: route edp-panel enable gpio
tlmm 74 was experimentally found to be panel enable pin, which shall be high for panel (both low-res IPS, OLED) to work. Define it as such.
--- .../arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dts | 12 +++++++++++- 1 file changed, 11 insertions(+), 1 deletion(-)
arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dts +11 -1
@@ -560,10 +560,13 @@ &mdss_dp3 { aux-bus { panel { - /* 1920x1200 IPS panel is SHP1593, PNP09FF compatible */ compatible = "edp-panel"; + enable-gpios = <&tlmm 74 GPIO_ACTIVE_HIGH>; power-supply = <&vreg_edp_3p3>; + pinctrl-0 = <&edp_bl_en>; + pinctrl-names = "default"; + port { edp_panel_in: endpoint { remote-endpoint = <&mdss_dp3_out>;
@@ -677,6 +680,13 @@ cam_indicator_en: cam-indicator-en-state { bias-disable; }; + edp_bl_en: edp-bl-en-state { + pins = "gpio74"; + function = "gpio"; + drive-strength = <2>; + bias-disable; + }; + edp_reg_en: edp-reg-en-state { pins = "gpio70"; function = "gpio";
Signature · 1 line
2.45.2
PATCH 2/2 arm64: dts: qcom: x1e80100-dell-xps13-9345: fix nvme regulator boot glitch
In reply to Aleksandrs VinarskisThe NVMe regulator has been left enabled by the boot firmware. Mark it as such to avoid disabling the regulator temporarily during boot.
Based on https://lore.kernel.org/all/[email protected]/
--- arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dts | 2 ++ 1 file changed, 2 insertions(+)
arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dts +2 -0
@@ -162,6 +162,8 @@ vreg_nvme: regulator-nvme { pinctrl-0 = <&nvme_reg_en>; pinctrl-names = "default"; + + regulator-boot-on; }; vreg_vph_pwr: regulator-vph-pwr {
Signature · 1 line
2.45.2
Re: [PATCH v1 2/2] arm64: dts: qcom: x1e80100-dell-xps13-9345: fix nvme regulator boot glitch
Quoted 7 lines · Aleksandrs Vinarskis
The NVMe regulator has been left enabled by the boot firmware. Mark it as such to avoid disabling the regulator temporarily during boot.
Based on https://lore.kernel.org/all/[email protected]/
Fixes f5b788d0e8cd ("arm64: dts: qcom: Add support for X1-based Dell XPS 13 9345")Signed-off-by Aleksandrs Vinarskis <[email protected]>
Johan
Rob Herring (Arm)
maintainerQuoted 14 lines · Aleksandrs Vinarskis
First round of improvements.
* Add experimentally discovered edp enable gpio. Drop panel info, as it is now documented in [1]
* Add Johan Hovold's fix for nvme regulator[1] https://lore.kernel.org/all/CAD=FV=Wu3vaY4Rtw4OZwgAf_b44JpDsKJhUa-EXiuu1hn3aJoQ@mail.gmail.com/
Aleksandrs Vinarskis (2):
arm64: dts: qcom: x1e80100-dell-xps13-9345: route edp-panel enable
gpio
arm64: dts: qcom: x1e80100-dell-xps13-9345: fix nvme regulator boot
glitch
Quoted 8 lines
.../boot/dts/qcom/x1e80100-dell-xps13-9345.dts | 14 +++++++++++++- 1 file changed, 13 insertions(+), 1 deletion(-)--
2.45.2
My bot found new DTB warnings on the .dts files added or changed in this series.
Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings are fixed by another series. Ultimately, it is up to the platform maintainer whether these warnings are acceptable or not. No need to reply unless the platform maintainer has comments.
If you already ran DT checks and didn't see these error(s), then make sure dt-schema is up to date:
pip3 install dtschema --upgrade
New warnings running 'make CHECK_DTBS=y qcom/x1e80100-dell-xps13-9345.dtb' for [email protected]:
arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dtb: phy@1bfc000: resets: [[53, 37], [53, 36]] is too long
from schema $id: http://devicetree.org/schemas/phy/qcom,sc8280xp-qmp-pcie-phy.yaml# arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dtb: phy@1bfc000: reset-names: ['phy', 'phy_nocsr'] is too long from schema $id: http://devicetree.org/schemas/phy/qcom,sc8280xp-qmp-pcie-phy.yaml# arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dtb: phy@1c06000: clocks: [[53, 107], [53, 109], [33, 1], [53, 111], [53, 113], [53, 115]] is too long from schema $id: http://devicetree.org/schemas/phy/qcom,sc8280xp-qmp-pcie-phy.yaml# arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dtb: phy@1c06000: clock-names: ['aux', 'cfg_ahb', 'ref', 'rchng', 'pipe', 'pipediv2'] is too long from schema $id: http://devicetree.org/schemas/phy/qcom,sc8280xp-qmp-pcie-phy.yaml# arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dtb: phy@1c0e000: clocks: [[53, 96], [53, 98], [33, 0], [53, 100], [53, 102], [53, 104]] is too long from schema $id: http://devicetree.org/schemas/phy/qcom,sc8280xp-qmp-pcie-phy.yaml# arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dtb: phy@1c0e000: clock-names: ['aux', 'cfg_ahb', 'ref', 'rchng', 'pipe', 'pipediv2'] is too long from schema $id: http://devicetree.org/schemas/phy/qcom,sc8280xp-qmp-pcie-phy.yaml#
arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dtb: usb@a2f8800: interrupt-names: ['pwr_event', 'dp_hs_phy_irq', 'dm_hs_phy_irq'] is too short
from schema $id: http://devicetree.org/schemas/usb/qcom,dwc3.yaml#arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dtb: system-cache-controller@25000000: reg: [[0, 620756992, 0, 2097152], [0, 622854144, 0, 2097152], [0, 624951296, 0, 2097152], [0, 627048448, 0, 2097152], [0, 629145600, 0, 2097152], [0, 631242752, 0, 2097152], [0, 633339904, 0, 2097152], [0, 635437056, 0, 2097152], [0, 637534208, 0, 2097152], [0, 639631360, 0, 2097152]] is too long
from schema $id: http://devicetree.org/schemas/cache/qcom,llcc.yaml#arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dtb: system-cache-controller@25000000: reg-names: ['llcc0_base', 'llcc1_base', 'llcc2_base', 'llcc3_base', 'llcc4_base', 'llcc5_base', 'llcc6_base', 'llcc7_base', 'llcc_broadcast_base', 'llcc_broadcast_and_base'] is too long
from schema $id: http://devicetree.org/schemas/cache/qcom,llcc.yaml#arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dtb: system-cache-controller@25000000: reg: [[0, 620756992, 0, 2097152], [0, 622854144, 0, 2097152], [0, 624951296, 0, 2097152], [0, 627048448, 0, 2097152], [0, 629145600, 0, 2097152], [0, 631242752, 0, 2097152], [0, 633339904, 0, 2097152], [0, 635437056, 0, 2097152], [0, 637534208, 0, 2097152], [0, 639631360, 0, 2097152]] is too long
from schema $id: http://devicetree.org/schemas/cache/qcom,llcc.yaml#arch/arm64/boot/dts/qcom/x1e80100-dell-xps13-9345.dtb: system-cache-controller@25000000: reg-names: ['llcc0_base', 'llcc1_base', 'llcc2_base', 'llcc3_base', 'llcc4_base', 'llcc5_base', 'llcc6_base', 'llcc7_base', 'llcc_broadcast_base', 'llcc_broadcast_and_base'] is too long
from schema $id: http://devicetree.org/schemas/cache/qcom,llcc.yaml#
Quoted 9 lines · Aleksandrs Vinarskis
First round of improvements.
* Add experimentally discovered edp enable gpio. Drop panel info, as it is now documented in [1]
* Add Johan Hovold's fix for nvme regulator[1] https://lore.kernel.org/all/CAD=FV=Wu3vaY4Rtw4OZwgAf_b44JpDsKJhUa-EXiuu1hn3aJoQ@mail.gmail.com/
[...]
Applied, thanks!
[1/2] arm64: dts: qcom: x1e80100-dell-xps13-9345: route edp-panel enable gpio
commit: 4e9b7787f80ae366f8a62a5a28955e134e522cc8
[2/2] arm64: dts: qcom: x1e80100-dell-xps13-9345: fix nvme regulator boot glitch
commit: 06d6fe987bda731b7c6619495aebedf638d37f2dBest regards,
Signature · 1 line
Bjorn Andersson <[email protected]>