patch "iio: filter: admv8818: Force initialization of SDO" added to char-misc-linus

This is a note to let you know that I've just added the patch titled

iio: filter: admv8818: Force initialization of SDO

to my char-misc git tree which can be found at
git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc.git
in the char-misc-linus branch.

The patch will show up in the next release of the linux-next tree (usually sometime within the next 24 hours during the week.)

The patch will hopefully also be merged in Linus's tree for the next -rc kernel release.

If you have any questions about this process, please let me know.

From cc2c3540d9477a9931fb0fd851fcaeba524a5b35 Mon Sep 17 00:00:00 2001
From: Sam Winchenbach <[email protected]>
Date: Mon, 3 Feb 2025 13:34:34 +0000
Subject: iio: filter: admv8818: Force initialization of SDO

When a weak pull-up is present on the SDO line, regmap_update_bits fails to write both the SOFTRESET and SDOACTIVE bits because it incorrectly reads them as already set.

Since the soft reset disables the SDO line, performing a read-modify-write operation on ADI_SPI_CONFIG_A to enable the SDO line doesn't make sense. This change directly writes to the register instead of using regmap_update_bits.

---
 drivers/iio/filter/admv8818.c | 14 ++++----------
 1 file changed, 4 insertions(+), 10 deletions(-)

index 848baa6e3bbf..d85b7d3de866 100644
@@ -574,21 +574,15 @@ static int admv8818_init(struct admv8818_state *st)
 	struct spi_device *spi = st->spi;
 	unsigned int chip_id;
 
-	ret = regmap_update_bits(st->regmap, ADMV8818_REG_SPI_CONFIG_A,
-				 ADMV8818_SOFTRESET_N_MSK |
-				 ADMV8818_SOFTRESET_MSK,
-				 FIELD_PREP(ADMV8818_SOFTRESET_N_MSK, 1) |
-				 FIELD_PREP(ADMV8818_SOFTRESET_MSK, 1));
+	ret = regmap_write(st->regmap, ADMV8818_REG_SPI_CONFIG_A,
+			   ADMV8818_SOFTRESET_N_MSK | ADMV8818_SOFTRESET_MSK);
 	if (ret) {
 		dev_err(&spi->dev, "ADMV8818 Soft Reset failed.\n");
 		return ret;
 	}
 
-	ret = regmap_update_bits(st->regmap, ADMV8818_REG_SPI_CONFIG_A,
-				 ADMV8818_SDOACTIVE_N_MSK |
-				 ADMV8818_SDOACTIVE_MSK,
-				 FIELD_PREP(ADMV8818_SDOACTIVE_N_MSK, 1) |
-				 FIELD_PREP(ADMV8818_SDOACTIVE_MSK, 1));
+	ret = regmap_write(st->regmap, ADMV8818_REG_SPI_CONFIG_A,
+			   ADMV8818_SDOACTIVE_N_MSK | ADMV8818_SDOACTIVE_MSK);
 	if (ret) {
 		dev_err(&spi->dev, "ADMV8818 SDO Enable failed.\n");
 		return ret;

2.48.1