mpu9150 magnetometer not working without powering accelerometer
Hi,
on the Epson Moverio BT-200 containing two MPU 9150 I see a strange behavior where I see only nearly fixed values until I enable the accelerometer or gyroscope shortly. I am a bit puzzled what is really going on here. It is the inv-mpu6050 driver.
Some tries:
root@bt200deb:~# cat /sys/bus/iio/devices/iio\:device1/in_magn_?_raw 27 27 27 root@bt200deb:~# cat /sys/bus/iio/devices/iio\:device1/in_magn_?_raw 26 26 26
x/y/z keep nearly the same and almost equal.
root@bt200deb:~# cat /sys/bus/iio/devices/iio\:device1/in_accel_?_raw 5950 -1782 14156
just one read from the accelerometer and things change for the magnetometer.
root@bt200deb:~# cat /sys/bus/iio/devices/iio\:device1/in_magn_?_raw 54 54 -2 root@bt200deb:~# cat /sys/bus/iio/devices/iio\:device1/in_magn_?_raw 61 57 1
a full power cycle later and operating at register level:
root@bt200deb:~# cat /sys/bus/iio/devices/iio\:device1/in_magn_?_raw 26 28 28 root@bt200deb:~#
force powering on the chip
root@bt200deb:~# echo on >/sys/bus/i2c/devices/1-0068/power/control root@bt200deb:~# cat /sys/bus/iio/devices/iio\:device1/in_magn_?_raw 26 28 31 root@bt200deb:~# i2cget -f -y 1 0x68 0x6C 0x3f -> PWR_MGMT_2 -> everything in standby
enable accelerometer axes:
root@bt200deb:~# i2cset -f -y 1 0x68 0x6C 0x7
putting accelerometer axes into standby:
root@bt200deb:~# i2cset -f -y 1 0x68 0x6C 0x3f
enable runtime powermangement
root@bt200deb:~# echo auto >/sys/bus/i2c/devices/1-0068/power/control root@bt200deb:~# cat /sys/bus/iio/devices/iio\:device1/in_magn_?_raw 57 59 -1
magnetometer working.
Does anyone have some hints what is going on here and what could be the real fix? Same behavior for the other mpu in the device head->scratch(); ...
Of course the accelerometer could be enabled in probe() but that feels more like a hackfix.
Regards,
Andreas