Skip to contentSkip to conversation

dt-bindings: interrupt-controller: Convert marvell,odmi-controller to DT schema

PATCH New Rob Herring (Arm) 1 participant 1 message May 5, 2025

Subsystems (2)
Device tree bindings irqchip drivers
lore
Share & tools
lore

Rob Herring (Arm)

author maintainer
#0 lore raw

PATCH 1/1 dt-bindings: interrupt-controller: Convert marvell,odmi-controller to DT schema

Convert the Marvell On-Die Message interrupt controller binding to schema format.

Drop the 'interrupt-controller' property which isn't relevant for an MSI controller.

Signed-off-by Rob Herring (Arm) <[email protected]>
---
 .../marvell,odmi-controller.txt               | 42 ---------------
 .../marvell,odmi-controller.yaml              | 54 +++++++++++++++++++
 2 files changed, 54 insertions(+), 42 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/interrupt-controller/marvell,odmi-controller.txt
 create mode 100644 Documentation/devicetree/bindings/interrupt-controller/marvell,odmi-controller.yaml
Documentation/devicetree/bindings/interrupt-controller/marvell,odmi-controller.txt deleted +0 -42
deleted file mode 100644
index 0ebfc952cb34..000000000000
@@ -1,42 +0,0 @@
-
-* Marvell ODMI for MSI support
-
-Some Marvell SoCs have an On-Die Message Interrupt (ODMI) controller
-which can be used by on-board peripheral for MSI interrupts.
-
-Required properties:
-
-- compatible           : The value here should contain:
-
-    "marvell,ap806-odmi-controller", "marvell,odmi-controller".
-
-- interrupt,controller : Identifies the node as an interrupt controller.
-
-- msi-controller       : Identifies the node as an MSI controller.
-
-- marvell,odmi-frames  : Number of ODMI frames available. Each frame
-                         provides a number of events.
-
-- reg                  : List of register definitions, one for each
-                         ODMI frame.
-
-- marvell,spi-base     : List of GIC base SPI interrupts, one for each
-                         ODMI frame. Those SPI interrupts are 0-based,
-                         i.e marvell,spi-base = <128> will use SPI #96.
-                         See Documentation/devicetree/bindings/interrupt-controller/arm,gic.yaml
-                         for details about the GIC Device Tree binding.
-
-Example:
-
-	odmi: odmi@300000 {
-		compatible = "marvell,ap806-odmi-controller",
-			     "marvell,odmi-controller";
-		interrupt-controller;
-		msi-controller;
-		marvell,odmi-frames = <4>;
-		reg = <0x300000 0x4000>,
-		      <0x304000 0x4000>,
-		      <0x308000 0x4000>,
-		      <0x30C000 0x4000>;
-		marvell,spi-base = <128>, <136>, <144>, <152>;
-	};
Documentation/devicetree/bindings/interrupt-controller/marvell,odmi-controller.yaml new file +54 -0

54 lines not on this page · raw message

Signature · 1 line
2.47.2