dt-bindings: interrupt-controller: Convert ti,omap-intc-irq to DT schema

deleted file mode 100644
index 38ce5d037722..000000000000
@@ -1,28 +0,0 @@
-Omap2/3 intc controller
-
-On TI omap2 and 3 the intc interrupt controller can provide
-96 or 128 IRQ signals to the ARM host depending on the SoC.
-
-Required Properties:
-- compatible: should be one of
-			"ti,omap2-intc"
-			"ti,omap3-intc"
-			"ti,dm814-intc"
-			"ti,dm816-intc"
-			"ti,am33xx-intc"
-
-- interrupt-controller : Identifies the node as an interrupt controller
-- #interrupt-cells : Specifies the number of cells needed to encode interrupt
-		     source, should be 1 for intc
-- interrupts: interrupt reference to primary interrupt controller
-
-Please refer to interrupts.txt in this directory for details of the common
-Interrupt Controllers bindings used by client devices.
-
-Example:
-	intc: interrupt-controller@48200000 {
-		compatible = "ti,omap3-intc";
-		interrupt-controller;
-		#interrupt-cells = <1>;
-		reg = <0x48200000 0x1000>;
-	};

52 lines not on this page · raw message

deleted file mode 100644
index f2583e6ec060..000000000000
@@ -1,27 +0,0 @@
-* OMAP Interrupt Controller
-
-OMAP2/3 are using a TI interrupt controller that can support several
-configurable number of interrupts.
-
-Main node required properties:
-
-- compatible : should be:
-	"ti,omap2-intc"
-- interrupt-controller : Identifies the node as an interrupt controller
-- #interrupt-cells : Specifies the number of cells needed to encode an
-  interrupt source. The type shall be a <u32> and the value shall be 1.
-
-  The cell contains the interrupt number in the range [0-128].
-- ti,intc-size: Number of interrupts handled by the interrupt controller.
-- reg: physical base address and size of the intc registers map.
-
-Example:
-
-	intc: interrupt-controller@1 {
-		compatible = "ti,omap2-intc";
-		interrupt-controller;
-		#interrupt-cells = <1>;
-		ti,intc-size = <96>;
-		reg = <0x48200000 0x1000>;
-	};
-