Skip to contentSkip to conversation

dt-bindings: PCI: Convert marvell,armada-3700-pcie to DT schema

PATCH Applied Rob Herring (Arm) 2 participants 2 messages Jul 10, 2025 – Jul 17, 2025

Subsystems (4)
lore
Share & tools
lore

Rob Herring (Arm)

author maintainer
#0 lore raw

PATCH 1/1 dt-bindings: PCI: Convert marvell,armada-3700-pcie to DT schema

Convert the Marvell Armada 3700 PCIe binding to DT schema format.

The 'clocks' property was missing and has been added.

---
 .../devicetree/bindings/pci/aardvark-pci.txt  | 59 -----------
 .../pci/marvell,armada-3700-pcie.yaml         | 99 +++++++++++++++++++
 MAINTAINERS                                   |  2 +-
 3 files changed, 100 insertions(+), 60 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/pci/aardvark-pci.txt
 create mode 100644 Documentation/devicetree/bindings/pci/marvell,armada-3700-pcie.yaml
Documentation/devicetree/bindings/pci/aardvark-pci.txt deleted +0 -59
deleted file mode 100644
index 2b8ca920a7fa..000000000000
@@ -1,59 +0,0 @@
-Aardvark PCIe controller
-
-This PCIe controller is used on the Marvell Armada 3700 ARM64 SoC.
-
-The Device Tree node describing an Aardvark PCIe controller must
-contain the following properties:
-
- - compatible: Should be "marvell,armada-3700-pcie"
- - reg: range of registers for the PCIe controller
- - interrupts: the interrupt line of the PCIe controller
- - #address-cells: set to <3>
- - #size-cells: set to <2>
- - device_type: set to "pci"
- - ranges: ranges for the PCI memory and I/O regions
- - #interrupt-cells: set to <1>
- - msi-controller: indicates that the PCIe controller can itself
-   handle MSI interrupts
- - msi-parent: pointer to the MSI controller to be used
- - interrupt-map-mask and interrupt-map: standard PCI properties to
-   define the mapping of the PCIe interface to interrupt numbers.
- - bus-range: PCI bus numbers covered
- - phys: the PCIe PHY handle
- - max-link-speed: see pci.txt
- - reset-gpios: see pci.txt
-
-In addition, the Device Tree describing an Aardvark PCIe controller
-must include a sub-node that describes the legacy interrupt controller
-built into the PCIe controller. This sub-node must have the following
-properties:
-
- - interrupt-controller
- - #interrupt-cells: set to <1>
-
-Example:
-
-	pcie0: pcie@d0070000 {
-		compatible = "marvell,armada-3700-pcie";
-		device_type = "pci";
-		reg = <0 0xd0070000 0 0x20000>;
-		#address-cells = <3>;
-		#size-cells = <2>;
-		bus-range = <0x00 0xff>;
-		interrupts = <GIC_SPI 29 IRQ_TYPE_LEVEL_HIGH>;
-		#interrupt-cells = <1>;
-		msi-controller;
-		msi-parent = <&pcie0>;
-		ranges = <0x82000000 0 0xe8000000   0 0xe8000000 0 0x1000000 /* Port 0 MEM */
-			  0x81000000 0 0xe9000000   0 0xe9000000 0 0x10000>; /* Port 0 IO*/
-		interrupt-map-mask = <0 0 0 7>;
-		interrupt-map = <0 0 0 1 &pcie_intc 0>,
-				<0 0 0 2 &pcie_intc 1>,
-				<0 0 0 3 &pcie_intc 2>,
-				<0 0 0 4 &pcie_intc 3>;
-		phys = <&comphy1 0>;
-		pcie_intc: interrupt-controller {
-			interrupt-controller;
-			#interrupt-cells = <1>;
-		};
-	};
Documentation/devicetree/bindings/pci/marvell,armada-3700-pcie.yaml new file +99 -0

99 lines not on this page · raw message

MAINTAINERS +1 -1
index 17085b8a393f..d0df1130d5ff 100644
@@ -18898,7 +18898,7 @@ M:	Pali Rohár <[email protected]>
 L:	[email protected]
 L:	[email protected] (moderated for non-subscribers)
 S:	Maintained
-F:	Documentation/devicetree/bindings/pci/aardvark-pci.txt
+F:	Documentation/devicetree/bindings/pci/marvell,armada-3700-pcie.yaml
 F:	drivers/pci/controller/pci-aardvark.c
 
 PCI DRIVER FOR ALTERA PCIE IP
Signature · 1 line
2.47.2
#1 lore raw
Quoted 5 lines · Rob Herring (Arm)

Convert the Marvell Armada 3700 PCIe binding to DT schema format.

The 'clocks' property was missing and has been added.

Applied, thanks!

[1/1] dt-bindings: PCI: Convert marvell,armada-3700-pcie to DT schema

      commit: 7d372e2a37af6e02a643f0be80020b05d29b45cc

Best regards,

Signature · 1 line
Manivannan Sadhasivam <[email protected]>