dt-bindings: gpio: Convert ti,keystone-dsp-gpio to DT schema

deleted file mode 100644
index 0423699d74c7..000000000000
@@ -1,39 +0,0 @@
-Keystone 2 DSP GPIO controller bindings
-
-HOST OS userland running on ARM can send interrupts to DSP cores using
-the DSP GPIO controller IP. It provides 28 IRQ signals per each DSP core.
-This is one of the component used by the IPC mechanism used on Keystone SOCs.
-
-For example TCI6638K2K SoC has 8 DSP GPIO controllers:
- - 8 for C66x CorePacx CPUs 0-7
-
-Keystone 2 DSP GPIO controller has specific features:
-- each GPIO can be configured only as output pin;
-- setting GPIO value to 1 causes IRQ generation on target DSP core;
-- reading pin value returns 0 - if IRQ was handled or 1 - IRQ is still
-  pending.
-
-Required Properties:
-- compatible: should be "ti,keystone-dsp-gpio"
-- ti,syscon-dev: phandle/offset pair. The phandle to syscon used to
-  access device state control registers and the offset of device's specific
-  registers within device state control registers range.
-- gpio-controller: Marks the device node as a gpio controller.
-- #gpio-cells: Should be 2.
-
-Please refer to gpio.txt in this directory for details of the common GPIO
-bindings used by client devices.
-
-Example:
-	dspgpio0: keystone_dsp_gpio@2620240 {
-		compatible = "ti,keystone-dsp-gpio";
-		ti,syscon-dev = <&devctrl 0x240>;
-		gpio-controller;
-		#gpio-cells = <2>;
-	};
-
-	dsp0: dsp0 {
-		compatible = "linux,rproc-user";
-		...
-		kick-gpio = <&dspgpio0 27>;
-	};

65 lines not on this page · raw message