dt-bindings: mailbox: Convert brcm,iproc-flexrm-mbox to DT schema

deleted file mode 100644
index bf0c998b8603..000000000000
@@ -1,59 +0,0 @@
-Broadcom FlexRM Ring Manager
-============================
-The Broadcom FlexRM ring manager provides a set of rings which can be
-used to submit work to offload engines. An SoC may have multiple FlexRM
-hardware blocks. There is one device tree entry per FlexRM block. The
-FlexRM driver will create a mailbox-controller instance for given FlexRM
-hardware block where each mailbox channel is a separate FlexRM ring.
-
-Required properties:
---------------------
-- compatible:	Should be "brcm,iproc-flexrm-mbox"
-- reg:		Specifies base physical address and size of the FlexRM
-		ring registers
-- msi-parent:	Phandles (and potential Device IDs) to MSI controllers
-		The FlexRM engine will send MSIs (instead of wired
-		interrupts) to CPU. There is one MSI for each FlexRM ring.
-		Refer devicetree/bindings/interrupt-controller/msi.txt
-- #mbox-cells:	Specifies the number of cells needed to encode a mailbox
-		channel. This should be 3.
-
-		The 1st cell is the mailbox channel number.
-
-		The 2nd cell contains MSI completion threshold. This is the
-		number of completion messages for which FlexRM will inject
-		one MSI interrupt to CPU.
-
-		The 3rd cell contains MSI timer value representing time for
-		which FlexRM will wait to accumulate N completion messages
-		where N is the value specified by 2nd cell above. If FlexRM
-		does not get required number of completion messages in time
-		specified by this cell then it will inject one MSI interrupt
-		to CPU provided at least one completion message is available.
-
-Optional properties:
---------------------
-- dma-coherent:	Present if DMA operations made by the FlexRM engine (such
-		as DMA descriptor access, access to buffers pointed by DMA
-		descriptors and read/write pointer updates to DDR) are
-		cache coherent with the CPU.
-
-Example:
---------
-crypto_mbox: mbox@67000000 {
-	compatible = "brcm,iproc-flexrm-mbox";
-	reg = <0x67000000 0x200000>;
-	msi-parent = <&gic_its 0x7f00>;
-	#mbox-cells = <3>;
-};
-
-crypto@672c0000 {
-	compatible = "brcm,spu2-v2-crypto";
-	reg = <0x672c0000 0x1000>;
-	mboxes = <&crypto_mbox 0 0x1 0xffff>,
-		 <&crypto_mbox 1 0x1 0xffff>,
-		 <&crypto_mbox 16 0x1 0xffff>,
-		 <&crypto_mbox 17 0x1 0xffff>,
-		 <&crypto_mbox 30 0x1 0xffff>,
-		 <&crypto_mbox 31 0x1 0xffff>;
-};

63 lines not on this page · raw message