Skip to contentSkip to conversation

man8: ip-sr: Document that passphrase must be high-entropy

PATCH New Eric Biggers 1 participant 1 message Aug 24, 2025

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH v3 1/1 man8: ip-sr: Document that passphrase must be high-entropy

'ip sr hmac set' takes a newline-terminated "passphrase", but it fails to stretch it. The "passphrase" actually gets used directly as the key. This makes it difficult to use securely.

I recommend deprecating this command and replacing it with a command that either stretches the passphrase or explicitly takes a key instead of a passphrase. But for now, let's at least document this pitfall.

---

Changed in v3:
- Dropped the update of the man page date
- Use /dev/random instead of /dev/urandom in the example Changed in v2:
- Use better example commmand for key generation

 man/man8/ip-sr.8 | 18 +++++++++++++++---
 1 file changed, 15 insertions(+), 3 deletions(-)
man/man8/ip-sr.8 +15 -3
index 6be1cc54..962fb0d1 100644
@@ -32,13 +32,21 @@ internal parameters.
 .PP
 Those parameters include the mapping between an HMAC key ID and its associated
 hashing algorithm and secret, and the IPv6 address to use as source for encapsulated
 packets.
 .PP
-The \fBip sr hmac set\fR command prompts for a passphrase that will be used as the
-HMAC secret for the corresponding key ID. A blank passphrase removes the mapping.
-The currently supported algorithms for \fIALGO\fR are \fBsha1\fR and \fBsha256\fR.
+The \fBip sr hmac set\fR command prompts for a newline-terminated "passphrase"
+that will be used as the HMAC secret for the corresponding key ID. This
+"passphrase" is \fInot\fR stretched, and it is used directly as the HMAC key.
+Therefore it \fImust\fR have enough entropy to be used as a key. For example, a
+correct use would be to use a passphrase that was generated using
+\fBhead\~-c\~32\~/dev/random\~|\~base64\~-w\~0\fR.
+.PP
+A blank "passphrase" removes the mapping.
+.PP
+The currently supported algorithms for \fIALGO\fR are \fBsha1\fR and
+\fBsha256\fR.
 .PP
 If the tunnel source is set to the address :: (which is the default), then an address
 of the egress interface will be selected. As this operation may hinder performances,
 it is recommended to set a non-default address.
 
@@ -52,7 +60,11 @@ it is recommended to set a non-default address.
 .nf
 # ip sr tunsrc set 2001:db8::1
 .SH SEE ALSO
 .br
 .BR ip-route (8)
+
+.SH BUGS
+\fBip sr hmac set\fR does not stretch the passphrase.
+
 .SH AUTHOR
 David Lebrun <[email protected]>

base-commit: 0ad8fef322365b7bafd052f416fc972bea49d362

Signature · 1 line
2.50.1