dt-bindings: pinctrl: Convert Marvell Berlin pinctrl to DT schema

deleted file mode 100644
index 0a2d5516e1f3..000000000000
@@ -1,47 +0,0 @@
-* Pin-controller driver for the Marvell Berlin SoCs
-
-Pin control registers are part of both chip controller and system
-controller register sets. Pin controller nodes should be a sub-node of
-either the chip controller or system controller node. The pins
-controlled are organized in groups, so no actual pin information is
-needed.
-
-A pin-controller node should contain subnodes representing the pin group
-configurations, one per function. Each subnode has the group name and
-the muxing function used.
-
-Be aware the Marvell Berlin datasheets use the keyword 'mode' for what
-is called a 'function' in the pin-controller subsystem.
-
-Required properties:
-- compatible: should be one of:
-	"marvell,berlin2-soc-pinctrl",
-	"marvell,berlin2-system-pinctrl",
-	"marvell,berlin2cd-soc-pinctrl",
-	"marvell,berlin2cd-system-pinctrl",
-	"marvell,berlin2q-soc-pinctrl",
-	"marvell,berlin2q-system-pinctrl",
-	"marvell,berlin4ct-avio-pinctrl",
-	"marvell,berlin4ct-soc-pinctrl",
-	"marvell,berlin4ct-system-pinctrl",
-	"syna,as370-soc-pinctrl"
-
-Required subnode-properties:
-- groups: a list of strings describing the group names.
-- function: a string describing the function used to mux the groups.
-
-Example:
-
-sys_pinctrl: pin-controller {
-	compatible = "marvell,berlin2q-system-pinctrl";
-
-	uart0_pmux: uart0-pmux {
-		groups = "GSM12";
-		function = "uart0";
-	};
-};
-
-&uart0 {
-	pinctrl-0 = <&uart0_pmux>;
-	pinctrl-names = "default";
-};

86 lines not on this page · raw message