arm64: dts: rockchip: clean up devicetree for 9Tripod X3568 v4
Subsystems (2)
PATCH 1/1 arm64: dts: rockchip: clean up devicetree for 9Tripod X3568 v4
Fix indentation, remove unused SDIO properties, and drop the GMAC clock that was used for input direction. The board uses the clock as output, so the input clock is not needed.
Signed-off-by Coia Prant <[email protected]>
--- .../dts/rockchip/rk3568-9tripod-x3568-v4.dts | 25 +++++++------------ 1 file changed, 9 insertions(+), 16 deletions(-)
arch/arm64/boot/dts/rockchip/rk3568-9tripod-x3568-v4.dts +9 -16
@@ -273,11 +273,10 @@ &gmac0 { clock_in_out = "output"; pinctrl-names = "default"; pinctrl-0 = <&gmac0_miim - &gmac0_tx_bus2 - &gmac0_rx_bus2 - &gmac0_rgmii_clk - &gmac0_rgmii_bus - &gmac0_clkinout>; + &gmac0_tx_bus2 + &gmac0_rx_bus2 + &gmac0_rgmii_clk + &gmac0_rgmii_bus>; phy-handle = <&rgmii_phy0>; phy-mode = "rgmii-id"; status = "okay";
@@ -290,11 +289,10 @@ &gmac1 { clock_in_out = "output"; pinctrl-names = "default"; pinctrl-0 = <&gmac1m1_miim - &gmac1m1_tx_bus2 - &gmac1m1_rx_bus2 - &gmac1m1_rgmii_clk - &gmac1m1_rgmii_bus - &gmac1m1_clkinout>; + &gmac1m1_tx_bus2 + &gmac1m1_rx_bus2 + &gmac1m1_rgmii_clk + &gmac1m1_rgmii_bus>; phy-handle = <&rgmii_phy1>; phy-mode = "rgmii-id"; status = "okay";
@@ -674,8 +672,7 @@ led_work_en: led_work_en { pmic { pmic_int: pmic_int { - rockchip,pins = - <0 RK_PA3 RK_FUNC_GPIO &pcfg_pull_up>; + rockchip,pins = <0 RK_PA3 RK_FUNC_GPIO &pcfg_pull_up>; }; };
@@ -763,7 +760,6 @@ &sdmmc0 { /* used for AP6275S WiFi */ &sdmmc2 { bus-width = <4>; - disable-wp; cap-sd-highspeed; cap-sdio-irq; keep-power-in-suspend;
@@ -771,9 +767,6 @@ &sdmmc2 { non-removable; pinctrl-names = "default"; pinctrl-0 = <&sdmmc2m0_bus4 &sdmmc2m0_cmd &sdmmc2m0_clk>; - sd-uhs-sdr12; - sd-uhs-sdr25; - sd-uhs-sdr50; sd-uhs-sdr104; vmmc-supply = <&vcc3v3_sys>; vqmmc-supply = <&vcc_1v8>;
Signature · 1 line
2.47.3
Quoted 5 lines · Coia Prant
Fix indentation, remove unused SDIO properties, and drop the GMAC clock that was used for input direction. The board uses the clock as output, so the input clock is not needed.
Applied, thanks!
[1/1] arm64: dts: rockchip: clean up devicetree for 9Tripod X3568 v4
commit: c1ffe499306b26a61f390b7d83c5703aa8e2af55
Best regards,
Signature · 1 line
Heiko Stuebner <[email protected]>