dmaengine: ti: k3-udma: enable compile testing
Subsystems (2)
PATCH 1/1 dmaengine: ti: k3-udma: enable compile testing
There does not seem to be anything preventing the K3 UDMA drivers from being compile tested (on arm64 as one dependency depends on ARM64) so enable compile testing for wider build coverage.
Note that the ring accelerator dependency can only be selected when "TI SOC drivers support" (SOC_TI) is enabled so select that option too.
--- drivers/dma/ti/Kconfig | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-)
drivers/dma/ti/Kconfig +3 -2
@@ -36,11 +36,12 @@ config DMA_OMAP config TI_K3_UDMA tristate "Texas Instruments UDMA support" - depends on ARCH_K3 + depends on ARCH_K3 || COMPILE_TEST depends on TI_SCI_PROTOCOL depends on TI_SCI_INTA_IRQCHIP select DMA_ENGINE select DMA_VIRTUAL_CHANNELS + select SOC_TI select TI_K3_RINGACC select TI_K3_PSIL help
@@ -49,7 +50,7 @@ config TI_K3_UDMA config TI_K3_UDMA_GLUE_LAYER tristate "Texas Instruments UDMA Glue layer for non DMAengine users" - depends on ARCH_K3 + depends on ARCH_K3 || COMPILE_TEST depends on TI_K3_UDMA help Say y here to support the K3 NAVSS DMA glue interface
Signature · 1 line
2.51.0
Quoted 8 lines · Johan Hovold
There does not seem to be anything preventing the K3 UDMA drivers from being compile tested (on arm64 as one dependency depends on ARM64) so enable compile testing for wider build coverage.
Note that the ring accelerator dependency can only be selected when "TI SOC drivers support" (
SOC_TI) is enabled so select that option too.[...]
Applied, thanks!
[1/1] dmaengine: ti: k3-udma: enable compile testing
commit: c381f1a38a4c7542cc6ec049d4dcff90a9423e89
Best regards,
Signature · 1 line
~Vinod