net: dlink: mask rx_coalesce/rx_timeout before writing RxDMAIntCtrl
Subsystems (2)
PATCH v2 1/1 net: dlink: mask rx_coalesce/rx_timeout before writing RxDMAIntCtrl
RxDMAIntCtrl encodes rx_coalesce in the low 16 bits and rx_timeout in the high 16 bits. If either value exceeds the field width, the current code may truncate the value and/or corrupt adjacent bits when programming the register.
Mask both values to 16 bits so only the intended fields are written.
Found by inspection.
Tested-on: D-Link DGE-550T Rev-A3
---
Changelog:
v2:
- drop unnecessary cast
v1: https://lore.kernel.org/netdev/[email protected]/
--- drivers/net/ethernet/dlink/dl2k.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
drivers/net/ethernet/dlink/dl2k.c +2 -1
@@ -590,7 +590,8 @@ static void rio_hw_init(struct net_device *dev)set_multicast (dev);if (np->coalesce) { -dw32 (RxDMAIntCtrl, np->rx_coalesce | np->rx_timeout <<16 ); +dw32 (RxDMAIntCtrl, (np->rx_coalesce &0x0000ffff ) | + (np->rx_timeout &0x0000ffff ) <<16 ); }/* Set RIO to poll every N*320nsec. */ dw8 (RxDMAPollPeriod,0x20 );
Signature · 1 line
2.52.0
Jakub Kicinski
maintainerQuoted 6 lines · On Sat, 3 Jan 2026 18:29:05 +0900 Yeounsu Moon wrote:
RxDMAIntCtrl encodes
rx_coalescein the low 16 bits andrx_timeoutin the high 16 bits. If either value exceeds the field width, the current code may truncate the value and/or corrupt adjacent bits when programming the register.Mask both values to 16 bits so only the intended fields are written.
Realistically IDK if this is worth it.
Paolo suggested in discussion on v1 that error checking could introduce a regression. If we take that concern seriously we can't change the (buggy) behavior at all.
That said the overflow is on frames, for values > 64k and the ring is 256 so IDK how high values could possibly work here in the first place.
Given this driver is using module params to configure coalescing I'd just leave this mess be. If you add ethtool configuration for coalescing make sure to correctly bound-check it.
Signature · 1 line
pw-bot: reject
Quoted 6 lines · Jakub Kicinski
Realistically IDK if this is worth it.
Paolo suggested in discussion on v1 that error checking could introduce a regression. If we take that concern seriously we can't change the (buggy) behavior at all.
Quoted 6 lines
That said the overflow is on frames, for values > 64k and the ring is 256 so IDK how high values could possibly work here in the first place.
Given this driver is using module params to configure coalescing I'd just leave this mess be. If you add ethtool configuration for coalescing make sure to correctly bound-check it.
Thanks for the feedback.
Understood. I'll drop this patch rather changing the current behavior.
If I add ethtool coalesce support for this driver, I'll make sure to valid and properly bound-check the values before writing the register.
Yeounsu Moon