xen/arm: Enable GICv3 by default for AArch32 MPU
PATCH 1/1 xen/arm: Enable GICv3 by default for AArch32 MPU
All the platforms where ARMv8R AArch32 is being tested use GICv3.
Signed-off-by Michal Orzel <[email protected]>
--- xen/arch/arm/Kconfig | 3 +-- 1 file changed, 1 insertion(+), 2 deletions(-)
xen/arch/arm/Kconfig +1 -2
@@ -128,8 +128,7 @@ config GICV2 config GICV3 bool "GICv3 driver" depends on !NEW_VGIC - default n if ARM_32 - default y if ARM_64 + default y if ARM_64 || MPU help Driver for the ARM Generic Interrupt Controller v3.
Signature · 1 line
2.43.0
Hi Michal,
Quoted 4 lines · Michal Orzel
All the platforms where ARMv8R AArch32 is being tested use GICv3.
Make sense i think.
Quoted 1 line
Signed-off-by Michal Orzel <[email protected]>
Acked-by Bertrand Marquis <[email protected]>
Cheers
Bertrand
Quoted 21 lines
---
xen/arch/arm/Kconfig | 3 +--1 file changed, 1 insertion(+), 2 deletions(-)xen/arch/arm/Kconfig +0
-0@@ -128,8 +128,7 @@ config GICV2config GICV3
bool "GICv3 driver"
depends on !NEW_VGIC
- default n ifARM_32
- default y ifARM_64
+ default y ifARM_64|| MPU
helpDriver for the ARM Generic Interrupt Controller v3.
Signature · 1 line
2.43.0