ALSA: hda/tas2781: Ignore reset check for SPI device
Subsystems (2)
PATCH 1/1 ALSA: hda/tas2781: Ignore reset check for SPI device
In the SPI driver probe, the device should be in the default state, so the device status check is not necessary. It should be forced to do the firmware download as I2C device.
Signed-off-by Baojun Xu <[email protected]>
--- .../hda/codecs/side-codecs/tas2781_hda_spi.c | 20 +++++++------------ 1 file changed, 7 insertions(+), 13 deletions(-)
sound/hda/codecs/side-codecs/tas2781_hda_spi.c +7 -13
@@ -631,7 +631,7 @@ static void tasdev_fw_ready(const struct firmware *fmw, void *context)struct tasdevice_priv *tas_priv = context;struct tas2781_hda *tas_hda =dev_get_drvdata (tas_priv->dev);struct hda_codec *codec = tas_priv->codec; -int ret, val; +int ret;guard (pm_runtime_active_auto)(tas_priv->dev);guard (mutex)(&tas_priv->codec_lock);
@@ -670,20 +670,14 @@ static void tasdev_fw_ready(const struct firmware *fmw, void *context) tas_priv->rcabin.profile_cfg_id =0 ; tas_priv->fw_state =TASDEVICE_DSP_FW_ALL_OK ; - ret =tasdevice_spi_dev_read (tas_priv, tas_priv->index, -TAS2781_REG_CLK_CONFIG , &val); -if (ret <0 ) - goto out; -if (val ==TAS2781_REG_CLK_CONFIG_RESET ) { - ret =tasdevice_prmg_load (tas_priv,0 ); -if (ret <0 ) { -dev_err (tas_priv->dev,"FW download failed = %d\n" , - ret); - goto out; - } - tas_priv->fw_state =TASDEVICE_DSP_FW_ALL_OK ; + ret =tasdevice_prmg_load (tas_priv,0 ); +if (ret <0 ) { +dev_err (tas_priv->dev,"FW download failed = %d\n" , ret); + goto out; } + tas_priv->fw_state =TASDEVICE_DSP_FW_ALL_OK ; +if (tas_priv->fmw->nr_programs >0 ) tas_priv->tasdevice[tas_priv->index].cur_prog =0 ;if (tas_priv->fmw->nr_configurations >0 )
Signature · 1 line
2.25.1