Skip to contentSkip to conversation

ALSA: hda/realtek: Add quirk for HP ENVY 13-aq1xxx

PATCH In review Tarun Noonemunthala 2 participants 2 messages Sep 23 – Sep 28 Sound

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ALSA: hda/realtek: Add quirk for HP ENVY 13-aq1xxx

The HP ENVY Laptop 13-aq1xxx (PCI SSID 103c:86ad) uses an ALC285 codec with two speaker pairs: front (pin 0x14) and bottom (pin 0x17).

The BIOS leaves pin 0x14 as [N/A] ("not connected"), so the generic parser never enables the front pair and only the bottom speakers are audible. The vendor driver (RTKVHD64.sys) programs that pin with the value 0x90170150 and runs the HP amplifier initialization, which is already implemented in the driver as ALC285_FIXUP_HP_GPIO_AMP_INIT.

Add a board fixup that applies the pin configuration for 0x14 and chains to the existing amplifier init fixup.

The pin value was recovered from the vendor driver's own configuration data. The patch and this changelog were prepared with an AI coding assistant (see the Assisted-by tag below); the change was reviewed and tested by the submitter on the affected machine.

Tested on an HP ENVY 13-aq1xxx by rebuilding snd-hda-codec-alc269 from the Fedora 7.1.10 source and loading it: the codec now reports "line_outs=2 (0x14/0x17)", pin 0x14 comes up as an output (Pin-ctls 0x40) with its amplifier unmuted, and both speaker pairs play.

Assisted-by OpenCode:deepseek-v4.1-flash checkpatch
---
 sound/hda/codecs/realtek/alc269.c | 11 +++++++++++
 1 file changed, 11 insertions(+)
sound/hda/codecs/realtek/alc269.c +11 -0
index 8f55c3c00..35d7d2f87 100644
@@ -4139,6 +4139,7 @@ enum {
 	ALC285_FIXUP_HP_SPECTRE_X360_EB1,
 	ALC285_FIXUP_HP_SPECTRE_X360_DF1,
 	ALC285_FIXUP_HP_ENVY_X360,
+	ALC285_FIXUP_HP_ENVY_13AQ,
 	ALC288_FIXUP_DELL_HEADSET_MODE,
 	ALC288_FIXUP_DELL1_MIC_NO_PRESENCE,
 	ALC288_FIXUP_DELL_XPS_13,
@@ -6412,6 +6413,15 @@ static const struct hda_fixup alc269_fixups[] = {
 		.chained = true,
 		.chain_id = ALC285_FIXUP_HP_GPIO_AMP_INIT,
 	},
+	[ALC285_FIXUP_HP_ENVY_13AQ] = {
+		.type = HDA_FIXUP_PINS,
+		.v.pins = (const struct hda_pintbl[]) {
+			{ 0x14, 0x90170150 }, /* front speakers */
+			{ }
+		},
+		.chained = true,
+		.chain_id = ALC285_FIXUP_HP_GPIO_AMP_INIT,
+	},
 	[ALC287_FIXUP_IDEAPAD_BASS_SPK_AMP] = {
 		.type = HDA_FIXUP_FUNC,
 		.v.func = alc285_fixup_ideapad_s740_coef,
@@ -7400,6 +7410,7 @@ static const struct hda_quirk alc269_fixup_tbl[] = {
 	SND_PCI_QUIRK(0x103c, 0x861f, "HP Elite Dragonfly G1", ALC285_FIXUP_HP_GPIO_AMP_INIT),
 	SND_PCI_QUIRK(0x103c, 0x864f, "HP Laptop 15-dy0xxx", ALC236_FIXUP_HP_MUTE_LED_COEFBIT2),
 	SND_PCI_QUIRK(0x103c, 0x869d, "HP", ALC236_FIXUP_HP_MUTE_LED),
+	SND_PCI_QUIRK(0x103c, 0x86ad, "HP ENVY 13-aq1xxx", ALC285_FIXUP_HP_ENVY_13AQ),
 	SND_PCI_QUIRK(0x103c, 0x86c1, "HP Laptop 15-da3001TU", ALC236_FIXUP_HP_MUTE_LED_COEFBIT2),
 	SND_PCI_QUIRK(0x103c, 0x86c7, "HP Envy AiO 32", ALC274_FIXUP_HP_ENVY_GPIO),
 	SND_PCI_QUIRK(0x103c, 0x86c8, "HP Laptop 14s-dr1xxx", ALC236_FIXUP_HP_MUTE_LED_COEFBIT2),
Signature · 1 line
2.55.0
#1 lore raw
Quoted 18 lines · Tarun Noonemunthala

The HP ENVY Laptop 13-aq1xxx (PCI SSID 103c:86ad) uses an ALC285 codec with two speaker pairs: front (pin 0x14) and bottom (pin 0x17).

The BIOS leaves pin 0x14 as [N/A] ("not connected"), so the generic parser never enables the front pair and only the bottom speakers are audible. The vendor driver (RTKVHD64.sys) programs that pin with the value 0x90170150 and runs the HP amplifier initialization, which is already implemented in the driver as ALC285_FIXUP_HP_GPIO_AMP_INIT.

Add a board fixup that applies the pin configuration for 0x14 and chains to the existing amplifier init fixup.

The pin value was recovered from the vendor driver's own configuration data. The patch and this changelog were prepared with an AI coding assistant (see the Assisted-by tag below); the change was reviewed and tested by the submitter on the affected machine.

Quoted 7 lines

Tested on an HP ENVY 13-aq1xxx by rebuilding snd-hda-codec-alc269 from the Fedora 7.1.10 source and loading it: the codec now reports "line_outs=2 (0x14/0x17)", pin 0x14 comes up as an output (Pin-ctls 0x40) with its amplifier unmuted, and both speaker pairs play.

Assisted-by OpenCode:deepseek-v4.1-flash checkpatch

Applied now. Thanks.

Takashi