Skip to contentSkip to conversation

leds: add "network" LED trigger (lan/wan/wlan)

PATCH In review Mieczyslaw Nalewaj 1 participant 1 message Nov 23, 2025 1 message not in the archive LED

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

PATCH 2/2 leds: add "network" LED trigger (lan/wan/wlan)

LED trigger for network interfaces.

- Aggregated per-family (lan/wan/wlan).
- Family and flags (link/tx/rx) are taken from led_cdev->params if present (format "network:<family>[ link][ tx][ rx]" or "<family>-online"). If params is NULL/empty they fall back to the LED device name:
     <colour>:<family>[-online]   e.g.  "green:wlan", "red:wan-online" or, if no colon exists, to the whole name.

Behaviour:
- wlan (normal): blink/solid driven by throughput table
- lan/wan (normal): one-shot blink on TX/RX packet change
- *-online variants: steady ON while any interface of the family has carrier

Interfaces are auto-tracked by name match (lan0, wan1, wlan2, phy0, wl1, ath0, ra0…). Up to MAX_IFACES (16) interfaces per family.

This trigger is intended for board/device authors and drivers to provide simple network-activity LED behaviour without per-interface wiring in userspace.

drivers/leds/trigger/Kconfig +0 -0
@@ -129,6 +129,15 @@ config LEDS_TRIGGER_NETDEV

       This allows LEDs to be controlled by network device activity. If unsure, say Y.

+config LEDS_TRIGGER_NETWORK
+    tristate "LED trigger for network interfaces"
+    depends on NET
+    help
+      Family (lan/wan/wlan) and flags are read from led_cdev->params +      ("network:wlan tx rx" or "network:lan-online") and, if missing, +      parsed from the LED name itself.
+      If unsure, say Y.
+
 config LEDS_TRIGGER_PATTERN
     tristate "LED Pattern Trigger"
     help

drivers/leds/trigger/ledtrig-network.c new file +718 -0

718 lines not on this page · raw message

drivers/leds/trigger/Makefile +0 -0
@@ -16,3 +16,4 @@ obj-$(CONFIG_LEDS_TRIGGER_NETDEV)    += led

 obj-$(CONFIG_LEDS_TRIGGER_PATTERN)    += ledtrig-pattern.o obj-$(CONFIG_LEDS_TRIGGER_TTY)        += ledtrig-tty.o obj-$(CONFIG_LEDS_TRIGGER_INPUT_EVENTS)    += ledtrig-input-events.o +obj-$(CONFIG_LEDS_TRIGGER_NETWORK)    += ledtrig-network.o