Not able to print env variable added in standalone application
Dear all,
I am in need of getting a status message from a standalone application.
Hence I am using getenv and setenv functions. The standalone application can read the env variable using getenv and set the registers accordingly. Based on what is set, I am trying to set some env variable using setenv function. The variable gets set I think. But I am not able to print that variable either in application or in uboot prompt ?
I am using run_command to jump to the standalone application which is
our requirement. But if I use "go" command from uboot prompt to run standalone application, I am able to print that env variable.
Could somebody help how to print env variable from standalone
application ?
Is there any other place in u-boot where I need to add this variable ?.
I have added it in CONFIG_EXTRA_ENV_SETTINGS.
Signature · 2 lines
View this message in context: http://www.nabble.com/Not-able-to-print-env-variable-added-in-standalone-application-tp23365798p23365798.html Sent from the Uboot - Users mailing list archive at Nabble.com.
Dear Kartheek N S,
Quoted 7 lines · In message <[email protected]> you wrote:
I am in need of getting a status message from a standalone application.
Hence I am using getenv and setenv functions. The standalone application can read the env variable using getenv and set the registers accordingly. Based on what is set, I am trying to set some env variable using setenv function. The variable gets set I think. But I am not able to print that variable either in application or in uboot prompt ?
If you cannot print that variable, what makes you then think that setting it has worked?
Adding some debug code to common/cmd_nvedit.c should be a trivial thing to do...
Quoted 1 line
I am using
run_commandto jump to the standalone application which is
And you think we can read from our crystall balls hoiw exactly you might be using "run_command"? Sorry, we're not that good.
Quoted 2 lines
our requirement. But if I use "go" command from uboot prompt to run standalone application, I am able to print that env variable.
Well, "go" is the official, documented interface to start a standalone application. If this works, then all is fine, no problem to be solve. Just use "go" then.
Quoted 2 lines
Could somebody help how to print env variable from standalone
application ?
You just wrote that it works if you use the correct command?
Quoted 2 lines
Is there any other place in u-boot where I need to add this variable ?.
I have added it inCONFIG_EXTRA_ENV_SETTINGS.
CONFIG_EXTRA_ENV_SETTINGS is completely unrelated to this.
Best regards,
Wolfgang Denk
Signature · 5 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de One does not thank logic. -- Sarek, "Journey to Babel", stardate 3842.4