Skip to contentSkip to conversation

Not getting the Uboot prompt for sbc2410x using u-boot1.1.6

U-Boot vishalD 2 participants 2 messages May 18, 2009

lore
Share & tools
lore

vishalD

author
#0 lore raw

Hi All,

I am new to uBoot.

I am using the sbc2410x board. I successfully compiled the uboot-1.1.6 for this board. But after downloading the uboot.bin to the flash, i am not getting the uboot prompt on serial terminal.

I am using the NAND flash. Do i have to make the changes for NAND flash and recompile the uboot?

Signature · 2 lines
View this message in context: http://www.nabble.com/Not-getting-the-Uboot-prompt-for-sbc2410x-using-u-boot1.1.6-tp23596126p23596126.html
Sent from the Uboot - Users mailing list archive at Nabble.com.
#1 lore raw

Dear vishalD,

Quoted 5 lines · In message <[email protected]> you wrote:

I am using the sbc2410x board. I successfully compiled the uboot-1.1.6 for this board. But after downloading the uboot.bin to the flash, i am not getting the uboot prompt on serial terminal.

U-Boot 1.1.6 is obsolete. Please use current code.

Best regards,

Wolfgang Denk

Signature · 6 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Looks clean and obviously correct to me, but then _everything_ I
write always looks obviously correct to me.  - Linus Torvalds in
<[email protected]>