IDE lockup after floppy access
After accessing a floppy disk, the kernel blocks on the first harddisk access. After a couple of seconds, the following messages appear:
hda: dma_time_expiry: dma status = 0x61
hda: DMA timeout error
I can only reset at this point. This is reproducible. I'm running kernel 2.6.0-test9 on an SMP system, but the problem doesn't go away when I boot with "nosmp". The kernel was built with CONFIG_PREEMPT. Here are the IDE startup messages:
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller at PCI slot 0000:00:07.1
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:piohda: QUANTUM FIREBALL CR13.0A, ATA DISK drive
hdb: TOSHIBA CD-ROM XM-6602B, ATAPI CD/DVD-ROM drive
Signature · 3 lines
Dick Streefland //// De Bilt [email protected] (@ @) The Netherlands ------------------------------oOO--(_)--OOo------------------
Does disabling CONFIG_PREEMPT cure the problem?
--bart
Quoted 9 lines · Dick Streefland
After accessing a floppy disk, the kernel blocks on the first harddisk access. After a couple of seconds, the following messages appear:
hda:
dma_time_expiry: dma status =0x61
hda: DMA timeout errorI can only reset at this point. This is reproducible. I'm running kernel 2.6.0-test9 on an SMP system, but the problem doesn't go away when I boot with "nosmp". The kernel was built with
CONFIG_PREEMPT.
Bartlomiej Zolnierkiewicz <[email protected]> wrote:
|
| Does disabling CONFIG_PREEMPT cure the problem?
No, I just tried without CONFIG_PREEMPT, but it still hangs.
Signature · 3 lines
Dick Streefland //// De Bilt [email protected] (@ @) The Netherlands ------------------------------oOO--(_)--OOo------------------
[email protected] (Dick Streefland) wrote:
| Bartlomiej Zolnierkiewicz <[email protected]> wrote: | | Does disabling CONFIG_PREEMPT cure the problem? | | No, I just tried without CONFIG_PREEMPT, but it still hangs.
I did some more tests (I'm becoming a big fan of the ext3 filesystem). The lockup also occurs with older kernels like 2.6.0-test1 and 2.4.20. A sure way to reproduce the problem is running the following one-liner with a DOS floppy in the drive:
find / & mdir
Disabling DMA with "hdparm -d0" doesn't help, although the kernel messages are different. I now get:
hda: lost interrupt
What could be the cause for this. Is my hardware dying? And if yes, what part? Any tips on how to isolate this problem? I know for sure that my floppy worked two months ago, but I don't known when it worked for the last time.
Signature · 3 lines
Dick Streefland //// De Bilt [email protected] (@ @) The Netherlands ------------------------------oOO--(_)--OOo------------------