Skip to contentSkip to conversation

AHCI driver for ICH6M

DISCUSSION Dominic ES. Ijichi 1 participant 1 message Feb 1, 2006 libata

lore
Share & tools
lore
#0 lore raw
Quoted 15 lines · ----- Erik Slagter
Quoted 1 line

I was trying to use the AHCI driver included in kernel 2.6.15 to

drive

Quoted 1 line

the SATA controller on my Asus Z71V laptop which supposedly has an

ICH6M

Quoted 1 line

controller. I noticed that the PCI ID of my controller shows up in

the

Quoted 1 line

AHCI source code, so I assume that means I should have support. I'm

not

Quoted 1 line

terribly good with linux or C, but I think I was able to

troubleshoot my

Quoted 1 line

issue down to a specific line of code. Ultimately, I get the

error:

Quoted 2 lines

ahci: probe of 0000:00:1f.2 failed with error -12

Quoted 9 lines

A very familiar problem. It means that your bios configures your ICH chipset for legacy (or whatever name it has) mode, which means it will
respond to the old-fashioned IDE ports and IRQs. This also means you cannot drive it in AHCI mode :-( unless there is an option in your BIOS
to switch between legacy and ahci mode, but afaik no single laptop has
this option. So you're on your own here :-( (just like me, btw).

i had same problem - fujitsu laptop with ich6 sata controller but with pata disk putting it into 'legacy/ide' mode. ahci module would drive the controller/disk but suspend didn't work. removing ahci module and adding ata_piix module resolved this issue for me, now i get full s3 suspend as well :) device naming stays the same so you might just get away with removing ahci module and redoing mkinitrd.

dom