Skip to contentSkip to conversation

PowerPC chipselects

U-Boot julianosam 2 participants 2 messages Nov 21, 2009 – Nov 30, 2009

lore
Share & tools
lore

julianosam

author
#0 lore raw

Hi. Im new with embedded systems. I have a board which has a powerpc 8313 processor on it, running a linux kernel + uboot.

In the PowerPC Local Bus, there is a chipset connected to the CS02 powerpc pin. The problem is, i don't know how to map the chipset memory into powerpc main memory. What config files I have to change?

I already have a device driver for the chipset, but i dont know what memory address i should io_remap() to talk to it!
The only information I have about the chipset is that it is connected to the CS02 pin, and the memory size needed is 0x8000 (32k).

Thanks

Signature · 2 lines
View this message in context: http://old.nabble.com/PowerPC-chipselects-tp26459494p26459494.html
Sent from the Uboot - Users mailing list archive at Nabble.com.
#1 lore raw
Quoted 7 lines · julianosam

Hi. Im new with embedded systems. I have a board which has a powerpc 8313 processor on it, running a linux kernel + uboot.

In the PowerPC Local Bus, there is a chipset connected to the CS02 powerpc pin. The problem is, i don't know how to map the chipset memory into powerpc main memory. What config files I have to change?

In the board config file, define CONFIG_SYS_BR2_PRELIM and CONFIG_SYS_OR2_PRELIM according to the values that you want programmed into the local bus controller (see the local bus section of the 8313 reference manual for details).

-Scott